ANR6653 - Afdekmoer

Uitverkocht

- €4,00

€4,00

€4,00 - €4,00

€4,00

Tip: Log in to your account to unlock volume discounts on this item.

Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.

Bolmoer - wartelmoer die een hydraulische leiding bevestigt aan een actuator in het ACE (Active Cornering Enhancement) stabilisatorstangsysteem.

Deze klemt de ACE hogedrukleidingwartel op de poort van de veerpootactuator, waardoor de verbinding behouden blijft die hydraulische druk naar de actuator toevoert; een Dowty afdichtring (bijbehorend onderdeel RYF100420) zit onder de wartel om de verbinding af te dichten.

Het ACE-hydrauliekcircuit is zeer gevoelig voor het binnendringen van vuil, dus de verbinding moet altijd zorgvuldig schoon worden gehouden wanneer deze wordt losgekoppeld.

Alternative Codes

ANR6653

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the ANR6653 domed nut used for?

The ANR6653 is a union nut that secures a hydraulic pipe to an actuator in the ACE (Active Cornering Enhancement) anti-roll bar system. It clamps the high-pressure pipe union onto the suspension actuator port.

What should I check before disconnecting this union nut?

The ACE hydraulic circuit is highly sensitive to dirt ingress, so keep the connection scrupulously clean whenever the ANR6653 is disturbed. Even small amounts of debris entering the open union can contaminate the system.

Does the ANR6653 need a new sealing washer when refitted?

Yes, a Dowty sealing washer (RYF100420) seats under the union to seal the joint, and it's good practice to fit a new one whenever the ANR6653 is removed rather than reusing the old washer.

Can the ANR6653 domed nut be reused?

It can typically be reused if it's undamaged and the threads are in good condition, since it's a mechanical union nut rather than a single-use fastener. Focus on renewing the sealing washer underneath it.