Doorgaan naar inhoud

AJU1136LLR - Moerwartel

- €6,00
€6,00
€6,00 - €6,00
€6,00
Tip: Log in to your account to unlock volume discounts on this item.
Genuine Part
Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.
Moerinsert Een eenvoudige push-in insert die wordt gebruikt om bekleding en paneelbevestigingen te verankeren.

In een opening in de carrosserie of een sierpaneel gedrukt, vormt het een vaste zitting die een bout of schroef vasthoudt, waardoor onderdelen zoals interieurpanelen en de zijdelingse ventilatieopening aan de voorspatbord kunnen worden bevestigd zonder toegang tot de achterkant van het paneel.
Alternative Codes
AJU1136LLR

Available to order 2–3 weeks

Not currently in stock. Order now — typically ships within 2–3 weeks.

Need it faster? Contact us about express import (2–5 business days).

When will my order arrive?

This item is ordered from our supplier on request. Typical lead time is 2–3 weeks from order confirmation.

  • Netherlands / Belgium / Germany: 2–4 working days after dispatch.
  • Other EU countries + UK: 4–8 working days after dispatch.
  • Outside EU/UK: contact us for an estimate.

Need it faster? Express import available in 2–5 business days — contact us before ordering.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the AJU1136LLR nut insert used for?
The AJU1136LLR is a push-in nut insert that anchors trim and panel fixings. Pressed into an aperture in the bodywork or trim, it forms a captive seat that retains a stud or screw, such as for interior trim panels or a side air vent.
How many nut inserts are typically needed?
Each insert anchors a single fixing point, so the number needed depends on how many original inserts your trim panel or vent uses. Check the panel before ordering rather than assuming just one.
What tools are needed to fit a nut insert?
Fitting is a simple push-fit into the panel aperture using hand pressure or a soft mallet. No specialist tools are required, just a clean, undamaged hole for it to seat into.