Doorgaan naar inhoud
533731 - Bearing Housing by Land RoverTransmission or Gearbox Part Land Rover Range Rover Series

533731 - Lagerhuis

Uitverkocht
- €81,70
€81,70
€81,70 - €81,70
€81,70
Genuine Part
Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.
Lagerhuis voor het achterste hoofdaslager van de LT76 vierversnellingsbak.

Het huis positioneert en borgt het lager dat de achterkant van de hoofdas van de versnellingsbak in de behuizing ondersteunt, waardoor deze concentrisch blijft zodat de as nauwkeurig draait. Het is een intern versnellingsbakonderdeel dat gewoonlijk wordt vernieuwd tijdens een revisie van de versnellingsbak.
Vehicle Model Land Rover Series 1
Land Rover Series 2 en 3
Fitment Notes Geschiktheidsgegevens beperkt — afgeleid van webonderzoek, controleer indien onzeker
SERIE I / II / IIA / III — Lagerhuis achterste hoofdas versnellingsbak (LT76 4-versnellingen)
Alternative Codes
533731

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the Bearing Housing and what does it do?
This Bearing Housing locates and retains the rear mainshaft bearing in the LT76 four-speed gearbox. It holds the bearing concentric so the rear of the gearbox mainshaft runs true within the casing. It's an internal component, usually renewed during a gearbox rebuild.
Which Land Rovers use this gearbox bearing housing?
This bearing housing fits the LT76 four-speed gearbox used in Land Rover Series 1, 2, 2A and 3. Fitment data on this part is limited, so check it against your gearbox type before ordering, as Series gearboxes changed over the production run.
When is the bearing housing usually replaced?
The bearing housing is typically renewed during a gearbox rebuild, when the rear mainshaft bearing is changed. If the bore is worn or the bearing has spun in it, the housing can't hold the bearing true, so it's replaced while the LT76 gearbox is stripped down.