Doorgaan naar inhoud
Onderdelen zoeken

ASR2220 - Achterzijpaneel

Uitverkocht
- €670,00
€670,00
€670,00 - €670,00
€670,00
Genuine Part
Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.
Achterste zijpaneel Rechterachterzijpaneel dat de achterhoek van de carrosserie vormt.

Het paneel bedekt de achterwielkast en het gebied tussen de achterzijkant en de opening van de achterklep, en sluit aan op de carrosseriebodem, de achterste stijl en de daklijn. Het bevat de bevestigingen voor de achterlichten en sierstrips en wordt gemonteerd voor herstel van ongevals- of corrosieschade aan de rechterachterzijde van de carrosserie. Het corresponderende linkerpaneel is ASR2221.
Alternative Codes
ASR2220

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the Rear Quarter Panel (ASR2220) used for?
The Rear Quarter Panel forms the right-hand rear corner of the bodyside, covering the rear wheel arch and the area between the rear bodyside and the tailgate aperture. It carries the rear lamp and trim mountings and is fitted for accident or corrosion repair. Genuine Land Rover part.
Which side of the vehicle does this quarter panel fit?
This quarter panel fits the right-hand rear of the body. The left-hand rear corner uses a separate, handed panel, so confirm you need the right-hand side before ordering. The two sides are not interchangeable.
Where does the rear quarter panel locate on the body?
The rear quarter panel locates against the body floor, the rear pillar and the roof line, covering the rear wheel arch up to the tailgate aperture. It carries the rear lamp and trim mountings, sitting as the outer skin of the right-hand rear corner.
Is fitting a rear quarter panel a DIY job?
Fitting a rear quarter panel is typically a bodyshop job, not a home repair. The panel is usually welded and aligned to the body floor and rear pillar, then finished and painted. Specialist tools and panel-fitting experience are normally needed for a correct result.