BPS020 - Verhoogde Luchtinlaat – 300TDi & TD5

Uitverkocht

- €237,00

€237,00

€237,00 - €237,00

€237,00

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Verhoogde luchtinlaat verplaatst de motorluchtinlaat van de standaardpositie in de binnenvleugel naar dakhoogte.

Langs de A-stijl omhoog, trekt hij inlaatlucht aan van boven de motorkaplijn om stofinname in droge omstandigheden te verminderen en om het inductiesysteem te beschermen tijdens waterdoorwadingen. Geschikt voor 300TDi- en TD5-dieseltoepassingen.

Vehicle Model Land Rover Defender tot 2016

Fitment Notes DEFENDER 1994-2006 — 300TDi/TD5 Diesel

Alternative Codes

BPS020

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is a Raised Air Intake used for?

A Raised Air Intake relocates the engine air pickup from the standard inner-wing position up to roof height on the Defender 300TDi and TD5. Running up the A-pillar, it draws cleaner air from above the bonnet line, reducing dust ingestion and helping protect the induction system during water crossings.

Which Defender engines does this fit?

This Raised Air Intake suits the Defender 300TDi and TD5 diesel applications (1994-2006). It's shaped for those engine bays and intake routings, so confirm your Defender runs the 300TDi or TD5 engine before ordering.

Does a raised air intake make a Defender waterproof for deep wading?

A Raised Air Intake raises the engine's air pickup point, which helps protect the induction system during water crossings, but it doesn't seal the rest of the vehicle. Axle, gearbox and other breathers, plus the electrics, still need attention before deep wading.

Is fitting a raised air intake a DIY job?

Fitting a Raised Air Intake to a Defender is typically a moderate DIY job. It usually involves drilling the front wing to route the intake up the A-pillar and connecting it to the existing air intake, so careful marking and sealing matter to keep the induction system watertight.