FRC2007 - Drukschijf – Keertandwiel

- €23,90

€23,90

€23,90 - €23,90

€23,90

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Axiale ring positioneert het achteruitrijtandwiel op zijn as in de vierversnellingsbak.

Het past over de as van het achteruitrijtandwiel en drukt tegen het tandwiel aan, waarbij het axiale stuwkracht opvangt en de axiale beweging van het tandwiel beperkt tijdens het draaien. Werkt in combinatie met de afstandshuls van de achteruitrias (onderdeel FRC2008).

Vehicle Model Land Rover Series 2 and 3

Fitment Notes Montagegegevens beperkt — afgeleid van online onderzoek, verifieer indien onzeker
SERIE III — Axiale ring, keertandwiel, 4-versnellingsbak, vanaf Suffix B

Alternative Codes

FRC2007

In stock 2 units

2 · Gouda 0 · Drachten

Express delivery available

When will my order arrive?

Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
Netherlands / Belgium / Germany: 2–4 working days.
Other EU countries + UK: 4–8 working days.
Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the FRC2007 thrust washer used for?

The FRC2007 thrust washer locates the reverse idler gear in the Land Rover four-speed gearbox. It fits over the reverse idler shaft and bears against the gear, taking axial thrust and limiting how far the gear moves endwise as it runs.

Which Land Rovers does the FRC2007 fit?

The FRC2007 fits the Land Rover Series 2 and 3 four-speed gearbox. Fitment follows the gearbox type rather than the model year, so confirm your vehicle has the four-speed unit before ordering.

How many FRC2007 thrust washers do I need, and why do they wear?

Typically one reverse idler thrust washer is fitted per four-speed gearbox. These washers usually wear slowly, allowing excess endfloat in the reverse idler gear that can cause whine or poor reverse engagement. They're normally renewed during a gearbox rebuild.

What's the difference between the FRC2007 and the FRC2008 thrust washer?

The FRC2007 is the thrust washer for the reverse idler gear, while the FRC2008 is the thrust washer for the reverse gear itself. Both sit in the same four-speed gearbox reverse train, so check which shaft you're working on to order the right one.