FRC2008 – Drukschijf – Achteruitversnelling

- €2,20

€2,20

€2,20 - €2,20

€2,20

Tip: Log in to your account to unlock volume discounts on this item.

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Druklagerring zit op de omkeeras in de vierversnellingsbak.

Hij fungeert als een afstandsstuk naast de druklagerring van de omkeerwiel, en regelt de axiale positie van het omkeerwiel op zijn as en vangt axiale druk op terwijl het tandwiel draait. Werkt in combinatie met de druklagerring van het omkeerwiel (aanvullend onderdeel FRC2007).

Vehicle Model Land Rover Series 2 and 3

Fitment Notes Fitmentgegevens beperkt - afkomstig van online onderzoek, controleer bij twijfel
SERIE III — Axiale ring / afstandsstuk achteruitversnelling, 4-versnellingsbak

Alternative Codes

FRC2008

In stock 8 units

3 · Gouda 5 · Drachten

Express delivery available

When will my order arrive?

Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
Netherlands / Belgium / Germany: 2–4 working days.
Other EU countries + UK: 4–8 working days.
Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the FRC2008 thrust washer used for?

The FRC2008 thrust washer sits on the reverse gear shaft in the Land Rover four-speed gearbox. It acts as a spacer that controls the endwise position of the reverse gear and takes axial thrust as the gear runs.

Which Land Rovers does the FRC2008 fit?

The FRC2008 fits the Land Rover Series 2 and 3 four-speed gearbox. Fitment depends on the gearbox type rather than the model year, so confirm your vehicle uses the four-speed unit before ordering.

How many FRC2008 washers are needed, and why do they wear?

Typically one reverse gear thrust washer is fitted per four-speed gearbox. These washers usually wear over time, letting the reverse gear move too far endwise, which can cause noise or weak reverse selection. They're usually replaced during a gearbox rebuild.

What's the difference between the FRC2008 and the FRC2007 thrust washer?

The FRC2008 is the thrust washer for the reverse gear, while the FRC2007 serves the reverse idler gear. Both live in the four-speed gearbox reverse train and look similar, so check which shaft you need before ordering.