NTC1312LR - Exhaust Bracket Exhaust Part Land Rover Range Rover Defender

NTC1312LR - Uitlaatbeugel

- €16,90

€16,90

€16,90 - €16,90

€16,90

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Uitlaatbeugel
- 90" 4-cilinder benzine (behalve MPI) en 2.5 NA

Vehicle Model Land Rover Defender tot 2016

Fitment Notes 90" 4-cilinder benzine (behalve MPI) en 2.5 NA

Alternative Codes

NTC1312GNTC1312NTC1312LR

In stock 1 unit

1 · Gouda 0 · Drachten

Express delivery available

When will my order arrive?

Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
Netherlands / Belgium / Germany: 2–4 working days.
Other EU countries + UK: 4–8 working days.
Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the NTC1312G exhaust clamp used for?

The NTC1312G is a rear exhaust clamp for the Defender 90 (1987-2006), joining sections of the rear exhaust system to keep the joint gas-tight. It's OEM quality and fits both 4-cylinder naturally aspirated diesel and petrol engines on the 90 inch wheelbase.

Which Defender 90 engines does this clamp fit?

It fits the 90 inch wheelbase Defender's 4-cylinder naturally aspirated diesel engines (both pre and post VIN AA267064) and all 4-cylinder petrol engines without a catalyst. Confirm your engine and VIN range before ordering, since clamp sizing varies by pipe diameter.

How many clamps are needed for a full rear exhaust replacement?

Typically one clamp is used per joint on the rear exhaust run, so a full rear section replacement usually needs at least one, sometimes two if the system has multiple joints. Check your existing exhaust for the number of joints before ordering.

Where on the vehicle does this clamp sit?

This clamp sits on the rear section of the Defender 90's exhaust system, at a pipe to pipe joint. It's not used on the front downpipe or the intermediate section, which use different clamp sizes.