ERR1976 - Stuurbekrachtingspompplaat

Uitverkocht

- €30,10

€30,10

€30,10 - €30,10

€30,10

Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.

Stuurbekrachtingspompplaat is de op de motor gemonteerde beugelplaat die de stuurbekrachtigingspomp (PAS) positioneert en ondersteunt op Defender 90/110-modellen die zijn uitgerust met stuurbekrachtiging van het Gemmer-type.

De plaat wordt aan de voorkant van het motorblok geschroefd en vormt het vaste montagevlak waartegen de PAS-pomp wordt bevestigd. Een correcte uitlijning van deze plaat is essentieel voor de juiste riemspanning en poelie-uitlijning op de aandrijving van de stuurbekrachtigingspomp. Van toepassing op 2.5L benzine, 2.5L atmosferische diesel, 2.5L turbodiesel en 200Tdi-aangedreven Defender-varianten.

Vehicle Model Land Rover Defender tot 2016

Fitment Notes DEFENDER 1987-2006 — 2.5L NA Diesel, 2.5L Turbo Diesel, 200 TDi, 2.5L Benzine

Alternative Codes

FOUT1976

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the power steering pump plate (ERR1976) for?

The power steering pump plate is the engine-mounted bracket that locates and supports the PAS pump on the Defender. It bolts to the front of the engine block and gives the pump a fixed mounting face, helping keep the drive belt and pulley aligned.

Which Defenders does this PAS pump plate fit?

This plate fits the Land Rover Defender (1987-2006) with the 2.5L petrol, 2.5L naturally aspirated diesel, 2.5L turbo diesel, or 200Tdi engine. It's the power steering pump bracket for these four-cylinder Defenders.

Why does correct fitting of this plate matter?

Correct fitting matters because the plate sets the position of the PAS pump and its pulley. If it isn't seated properly, belt tension and pulley alignment suffer, which can lead to belt wear or squeal. Make sure the mounting face is clean before bolting it up.