ESR439 - Uitlaatdemperbehuizing

Uitverkocht

- €270,00

€270,00

€270,00 - €270,00

€270,00

Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.

Uitlaatdemper montage voor het achterste dempergedeelte van het uitlaatsysteem op 2.5L 4-cilinder 300 TDi dieseltoepassingen.

De demper vermindert het uitlaatgeluid wanneer de uitlaatgassen door het achterste deel van de uitlaatleiding stromen, alvorens ze via de uitlaatpijp worden afgevoerd.

Vehicle Model Land Rover Defender tot 2016

Fitment Notes DEFENDER 1987-2006 — 110 & 130 wielbasis, 2.5L 4Cyl TDi (300Tdi) diesel. Achterdemper / uitlaatdemper montage

Alternative Codes

ESR439

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the ESR439 Exhaust Box Assembly?

The ESR439 Exhaust Box Assembly is the rear silencer section of the exhaust on the Defender 300Tdi. It attenuates exhaust gas noise as gases pass through the rear of the exhaust line before discharge at the tailpipe. Genuine Land Rover part.

Which vehicles does it fit?

This exhaust box fits the Defender 1987-2006 in 110 and 130 wheelbase with the 2.5L 4-cylinder 300Tdi diesel engine. It's specified for the 110 and 130 wheelbase, so confirm your wheelbase and engine before ordering, as shorter wheelbase or other engines use a different silencer.

What are the signs the exhaust box needs replacing?

A failing exhaust box usually shows up as a louder, blowing exhaust note, a rattle from a broken internal baffle, or visible corrosion and holes in the box body. On the Defender 300Tdi, road salt and age typically rot the rear silencer first, so it's a common replacement.

What's needed to fit it?

Fitting the exhaust box typically needs the clamps and mounting rubbers that support the rear silencer, which may not be included, so check what you're reusing. It's usually a straightforward job on a ramp or axle stands, though corroded clamps often have to be cut off.