DA4063 - Uitlaatklem – 60mm

- €2,60

€2,60

€2,60 - €2,60

€2,60

Tip: Log in to your account to unlock volume discounts on this item.

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Uitlaatklem geschikt voor 60mm nominale pijp, onderdeel van het uitlaatsysteem.

Deze klemt een schuifpassing tussen twee aangrenzende uitlaatsecties, waarbij de buitenste pijp op de binnenste sectie wordt gedrukt om de verbinding op zijn plaats te houden en een gasdichte afdichting te garanderen.

Alternative Codes

250-260GA4063DA4063

In stock 24 units

15 · Gouda 9 · Drachten

Express delivery available

When will my order arrive?

Order before 15:00 (Mon–Fri): same-day dispatch for in-stock items.
UPS Express (order before 14:00): dispatched today, delivered tomorrow where available.
Netherlands / Belgium / Germany: 2–4 working days.
Other EU countries + UK: 4–8 working days.
Outside EU/UK: delivery times vary — contact us for an estimate.

Items may ship from multiple warehouses at no extra cost.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the 60mm exhaust clamp used for?

The 60mm exhaust clamp secures a slip-fit joint between two exhaust sections sized for 60mm nominal pipe. It compresses the outer pipe onto the inner section, holding the joint in alignment and maintaining a gas-tight seal in the exhaust system.

How do I know if I need the 60mm size?

Measure the nominal diameter of your exhaust pipe at the joint. This clamp fits 60mm pipe; a 65mm version is available for larger sections. Getting the size right ensures the clamp grips the pipe fully and seals the joint.

How many exhaust clamps are typically needed?

Typically one clamp secures each slip-fit joint, so a single section replacement usually needs one. A full exhaust system swap usually uses several, one at each joint. Check how many joints your repair involves before ordering.

Can I fit this exhaust clamp at home?

Yes, fitting the 60mm exhaust clamp is typically a DIY job needing only basic spanners or a socket. Slide it over the slip-fit joint and tighten evenly. Working on a cold exhaust and applying penetrating oil to old fasteners usually helps.