Land Rover Parts

Screw is a fixing screw used to secure exterior lamp, interior lamp and trim components to the body. It retains fittings such as the high-level st...

Clip - retaining for rubbing strip - rear quarter

Locking Nut for Land Rover applications.

Pipe Clip used to secure and route pipework such as fuel breather and roll-over anti-spill lines. The clip holds the pipe at a fixed point to prev...

Halogen Bulb - H3 12V 55W. Single-filament halogen type, standard H3 specification rated 55W at 12V. Commonly used in front fog lights and auxiliar...

Rear Mudflap Mounting Angle, the angled bracket that secures a rear mudflap to the underbody. It positions and supports the mudflap behind the rea...

strap MTC8527

O-Ring, 76.5mm, used in the engine cooling circuit to seal the coolant pump (water pump) and thermostat housing joints. The O-ring maintains a lea...

Exhaust Pipe Clamp for the front exhaust pipe joint. Clamps the front exhaust pipe at its connection, holding the joint tight and gas-tight agains...

Rear Roof Rail Gasket for the roof side-rail mounting assembly. This gasket seats between the rear of the side roof rail and the roof panel, seali...

Clip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.

Sealing Ring for the Exhaust Gas Recirculation (EGR) system, measuring 31.03 x 3.5 mm. This O-ring seals a joint in the EGR circuit, containing re...

Oil Filter Assembly for the 3.2L DOHC MPI petrol inline-six engine, forming part of the engine lubrication circuit. The filter mounts on the oil f...

O-Ring sealing a connection at the inlet manifold, including the EGR valve-to-manifold joint on diesel applications. The elastomer ring seats in a...

A/C O-Ring - a sealing O-ring for the air conditioning refrigerant hose connections on the Td5 engine. It seats at the coupling between refrigeran...

5th Gear Housing Gasket for the LT85 5-speed manual gearbox. Seals the joint between the fifth-gear housing (rear extension) and the gearbox casin...

Seat Belt Clip is a retaining clip for the front seat belt in the occupant restraint system. It secures and locates the seat belt webbing at the f...

Exhaust Bracket locates and supports the exhaust system, securing a section of the exhaust to the underbody to control movement and isolate vibration.

Blanking Plug Fills the headlamp washer jet aperture in the front bumper on vehicles not fitted with headlamp washers. It presses into the moulded ...

Door Glass Channel Shim - a spacer used within the front door to set the glass run channel against the window regulator. The shim takes up clearan...

Special Nut is an M8 blind nutsert, a threaded insert set into a panel to create a captive fixing point. Installed from one side of the panel, it ...

Self-Tapping Screw Set is a set of general-purpose self-tapping fixings used at panel, trim, finisher and bracket mounting points throughout the ve...

Rocker Shaft Stud for the cylinder head valve train, securing a rocker shaft pedestal to the cylinder head. The stud locates and clamps the rocker...

Finger Pull for the side door sliding glass window. The outer grip fitted to the sliding glass pane, used to slide the window open and closed.