Land Rover Parts

Parking Brake Cable (right-hand) transmits parking brake actuation from the hand lever to the right rear brake. Routed along the underbody, it lin...

Floor Mats - a set of tailored contour mats shaped to follow the footwell profile of the interior. The mats lay over the original carpet to protec...

Crankshaft Gear is the lower timing gear mounted on the crankshaft nose within the timing drive assembly. It drives the timing chain from the cran...

Brake Pad Set - Rear provides the friction pads for the rear disc brakes. The pads sit in the rear caliper either side of the disc; when the brake...

Side Step Tube in stainless steel, forming part of the exterior side-protection and cabin-access assembly. Mounted along the lower body side, the ...

Washer Jet is part of the rear screen wash system. It directs washer fluid onto the rear window, feeding from the washer circuit to clear the glas...

Exhaust Pipe Mounting Bracket for the 2.2L DW12 diesel engine, part of the exhaust system support assembly. The bracket locates and supports the e...

Crankshaft Damper - the torsional vibration damper mounted on the front of the crankshaft. It counteracts the rotational oscillations set up by the...

Bare Cylinder Block for the 4.0L Rover V8 petrol engine. This is the main structural casting of the engine, housing the cylinder bores, crankcase a...

Cylinder Block Grommet seals a machined opening in the engine cylinder block, closing off a core or service passage in the block casting to prevent...

Body-to-Chassis Mounting Bracket forming part of the body mounting assembly of the Defender 90, 110 and 130. It provides an attachment point secur...

Bracket for a lashing / recovery ring, part of the body and chassis tie-down provision. It provides the mounting point for a lashing or recovery r...

Insulator

Air Duct for the heater assembly cold-air intake, left-hand-drive diesel applications. Channels fresh air from the intake aperture into the heater...

Transfer Box Gear Knob in aluminium, fitted to the high/low range selector lever of the LT230 transfer box. The knob threads onto the top of the t...

Breather Tube

Oil Cooler - a transmission oil cooler forming part of the gearbox cooling circuit. Transmission fluid is routed through a finned matrix so that he...

Pinion Shaft is the input (primary pinion) shaft of the R380 five-speed manual gearbox. It carries drive from the clutch into the gearbox and mesh...

Thrust Washer for the gearbox mainshaft. The washer controls mainshaft end-float and carries axial thrust loads within the 5-speed manual transmis...

Stud Bolt for the LT230 transfer box. It clamps a casing joint on the transfer box, securing the main casing and speedometer housing joints.

Selector Arm for the LT230 transfer box gearchange. It transfers movement from the transfer gear lever to the high and low range selector mechanism.

Rear Output Shaft is the driven shaft at the rear of the LT230 transfer box, transmitting drive from the transfer gearbox to the rear propeller sha...

Front Door Latch Assembly for the left-hand front door latching system on left-hand-drive vehicles. The assembly houses the latch mechanism that e...

Front Door Latch Assembly for the right-hand front door latching system on left-hand-drive vehicles. The assembly houses the latch mechanism that ...

Front Door Latch Assembly for the left-hand front door latching system. The assembly houses the latch mechanism that engages the striker on the bo...

Front Door Latch Assembly for the right-hand front door latching system. The assembly houses the latch mechanism that engages the striker on the b...