Skip to content
8–23 August: reduced summer staffing. Orders may take up to 5 extra working days to dispatch and emails up to 2 working days to answer. Thanks for your patience.
8–23 Aug: orders may ship up to 5 days later.

ERR1976 - Power Steering Pump Plate

Sold out
- €30,10
€30,10
€30,10 - €30,10
€30,10
Genuine Part
Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.
Power Steering Pump Plate is the engine-mounted bracket plate that locates and supports the power-assisted steering (PAS) pump on Defender 90/110 models fitted with Gemmer-type power steering.

The plate bolts to the front of the engine block and provides the fixed mounting face against which the PAS pump is secured. Correct alignment of this plate is essential for proper belt tension and pulley alignment on the steering pump drive. Applicable to 2.5L petrol, 2.5L naturally aspirated diesel, 2.5L turbo diesel, and 200Tdi-engined Defender variants.
Vehicle Model Land Rover Defender up to 2016
Fitment Notes DEFENDER 1987-2006 — 2.5L NA Diesel, 2.5L Turbo Diesel, 200 TDi, 2.5L Petrol
Alternative Codes
ERR1976

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the power steering pump plate (ERR1976) for?
The power steering pump plate is the engine-mounted bracket that locates and supports the PAS pump on the Defender. It bolts to the front of the engine block and gives the pump a fixed mounting face, helping keep the drive belt and pulley aligned.
Which Defenders does this PAS pump plate fit?
This plate fits the Land Rover Defender (1987-2006) with the 2.5L petrol, 2.5L naturally aspirated diesel, 2.5L turbo diesel, or 200Tdi engine. It's the power steering pump bracket for these four-cylinder Defenders.
Why does correct fitting of this plate matter?
Correct fitting matters because the plate sets the position of the PAS pump and its pulley. If it isn't seated properly, belt tension and pulley alignment suffer, which can lead to belt wear or squeal. Make sure the mounting face is clean before bolting it up.