FRC1201 - Differential Shim – 0.068in

Sold out

€6,80 - €6,80

€6,80

€6,80 - €6,80

€6,80

Tip: Log in to your account to unlock volume discounts on this item.

Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.

Differential Pinion Bearing Shim - 0.068 in, for use in the Rover 10-spline rear differential. This shim sets the preload on the pinion outer bearing during differential assembly or rebuild.

Thickness: 0.068 in. Sold individually.

Vehicle Model Land Rover Defender up to 2016
Land Rover Discovery 1 1989-1998 (L318)
Range Rover Classic up to 1994
Land Rover Series 2 and 3

Fitment Notes SERIES II/IIA/III — Rover 10-spline diff
DEFENDER to (V) KA (1993) — Rover 10-spline diff
DISCOVERY 1 — Rover 10-spline diff
RANGE ROVER CLASSIC 1970-1994 — Rover 10-spline diff

Alternative Codes

FRC1201

Not available

This item is currently unavailable. Contact us for alternatives.

Notify me when back in stock

Rather wait until it is in stock? Leave your email address and we will email you the moment it arrives. No newsletter.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the FRC1201 differential shim used for?

The FRC1201 is a 0.068in pinion bearing shim for the Rover-type 10-spline differential. It sets the preload on the pinion outer bearing during differential assembly or rebuild. It fits the Rover diff used on the Series 2 and 3, Defender, Discovery 1 and Range Rover Classic.

How do I know if I need the 0.068in shim?

The 0.068in is one thickness in a range of pinion shims, and the correct size is set by measurement during pinion bearing preload setup. Confirm your differential is the Rover 10-spline type, then choose the shim thickness from your measured preload figure.

Where does the FRC1201 shim sit in the differential?

The FRC1201 shim sits behind the pinion outer bearing in the Rover-type 10-spline differential, where it controls pinion bearing preload. It's a drivetrain setup part fitted during diff build, and the 0.068in thickness must match what your bearing setup calls for.