Skip to content

RTC6481 - Seal

Sold out
€64,00 - €64,00
€64,00
€64,00 - €64,00
€64,00
Genuine Part
Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.
Seal
Vehicle Model Land Rover Discovery 1 1989-1998 (L318)
Fitment Notes DISCOVERY 1 1989-1998 — Rubber sunroof seal; front sunroof assembly (from VIN JA034313) and rear sunroof assembly
Alternative Codes
RTC6481

Not available

This item is currently unavailable. Contact us for alternatives.

Notify me when back in stock

Rather wait until it is in stock? Leave your email address and we will email you the moment it arrives. No newsletter.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the RTC6481 seal used for?
RTC6481 is a genuine rubber seal for the Discovery 1 sunroof, sealing either the front or rear sunroof assembly against water and wind noise. It sits around the glass panel edge where it meets the roof aperture.
Does RTC6481 fit both the front and rear sunroof?
It fits both, but the front sunroof application only applies from VIN JA034313 onward. Check your chassis plate if fitting the front seal on an earlier Discovery 1, as pre-JA034313 vehicles used a different front sunroof design.
Where exactly does this seal sit on the sunroof?
It runs around the perimeter of the sunroof glass panel, sealing the gap between the glass and the roof aperture frame. A perished seal is the most common cause of sunroof leaks and wind noise on the Discovery 1.
Should I replace the seal every time I remove the sunroof panel?
It's good practice to fit a new seal whenever the sunroof panel is removed, since the rubber typically loses its seal once disturbed or aged. Reusing a hardened or cracked seal risks a leak coming back.