Land Rover Accessories

Front Floor Contour Mat Kit is a pair of shaped rubber mats for the front cabin footwells, forming part of the interior floor protection. Each mat...

LED Light Bar rated at 72W, an auxiliary driving and work lamp for supplementary forward illumination. It mounts to the front bar, roof or bodywork...

Tubular Winch Bumper - Without A-Bar, Without Air Conditioning - one-piece tubular front bumper with integral winch mounting, for vehicles built wi...

Light Guard Set - protective guards for the rear lamp units, mounted on the rear wings. The guards fit over the rear lamp lenses and shield them a...

Decal featuring the Union Jack flag design, measuring 40 × 25 mm, printed in full colour. A decorative self-adhesive decal suitable for applicatio...

Snatch Block (Winch Pulley) - recovery pulley used in the winch rigging to redirect the winch cable and enable double-line pulling. Rated to 9,000...

XS Vent Set Silver with Black Mesh (Pair)

Mudflap Bracket - Front - LH secures the front mudflap to the body on the left-hand side of the vehicle. Part of the front mudflap assembly, the b...

Mudflap Bracket for the front, right-hand side. This bracket secures the front mudflap to the body, holding it at the correct position behind the ...

Tyre Repair Kit for external plug repair of punctures in tubeless tyres, intended for off-road and emergency use. A puncture can be repaired with ...

Jerry Can Seal - replacement sealing gasket for a fuel jerry can. It seats in the can's cap or filler closure and seals it against fuel and vapour...

LED Light Bar - a 126W auxiliary LED lamp providing supplementary forward lighting. Measuring approximately 560mm long, the bar carries a row of h...

Portable Jump Starter and Air Compressor - a handheld 12V power pack combining a battery jump starter, power bank, tyre inflator and LED work light...

Snow Cowl for the wing-top heater air intake, fitting in place of the standard intake grille on the left-hand wing of right-hand-drive vehicles. T...

Front Spot Lamp Bar in nylon-coated steel, bolting to the front of the vehicle to carry auxiliary driving and spot lamps. The bar provides the mou...

Waffle-Pattern Jack Base for use under a Hi-Lift style jack. The wide plate spreads the jack's load and its waffle pattern grips soft or uneven gro...

Roof Console - an overhead interior console that adds cabin storage and a single-DIN mounting provision. The single-DIN aperture accepts a stereo ...

Lockable Cubby Box is a centre-console storage box that mounts on the transmission tunnel between the front seats, providing a secure enclosed comp...

Rear Lamp Guard fits over the rear lamp unit to protect the lens and housing from impact damage. It shields the light cluster from knocks by branc...

Wiring Connector Set for 12-volt Land Rover electrical systems. Supplied as a set of connectors for use in wiring repair or modification work.

Rear Lamp Guards - a pair of slatted steel guards fitted over the rear lamp assemblies to protect the lenses and lamp bodies from stone chips, bran...

Brake Hose Kit is a set of flexible hydraulic brake hoses for the front and rear braking circuits, supplied at +40mm over standard length to suit r...

Sliding Window Kit - a pair of sliding side windows fitted with green-tinted toughened glass certified to E11 CE R-43. The sliding panes provide op...

Upgrade the rear braking system on your Land Rover with this performance rear brake discs set (pair), featuring a slotted and drilled design. The d...

Brake Disc for the front axle, internally vented with a cross-drilled and grooved face. Part of the braking system, providing the friction surface...

Driving Lights are supplied as a matched pair of front auxiliary lamps used to improve forward illumination. They are designed to mount on the comp...

Rear Spring Spacer Kit for the coil-spring rear suspension, supplied as a pair of blocks that fit between the axle and the spring seats to raise ri...

Front Bumperette - a compact protection unit fitted at the front of the vehicle. It provides localised impact protection to the front end. Manufac...

Portable Twin-Cylinder Air Compressor, a self-contained 12V DC unit for tyre inflation and general workshop air supply. The twin-cylinder pump (40...

Internal Floor Chequer Plate is an aluminium protective covering for the internal cabin floor. The chequer-pattern aluminium plate fits over the f...

Static Lap Belt - a two-point lap seat belt for a centre or side-facing seating position. The webbing is a fixed length and is adjusted by hand to...

Jerry Can Holder is a mounting bracket that holds and secures a 20-litre jerry can to the vehicle for carrying spare fuel or water. The can is clam...

Spare Wheel Cover - a soft cover that fits over an externally mounted spare wheel to shield the tyre and rim from dirt, road grime, moisture and UV...

Spare Wheel Cover fits over an externally mounted spare wheel to protect the tyre and wheel from weather, road dirt and UV exposure. This is the h...

Roller Fairlead - zinc coated - for steel cable winches. This four-roller fairlead mounts to the front of a winch bumper and guides the steel cabl...

Spare Wheel Carrier mounts to the rear door to carry the spare wheel externally. It bolts through the door and provides the stud plate onto which ...

Rear Coil Spring - part of the rear suspension, supporting the vehicle weight and setting ride height at the rear axle. Uprated to give a +50mm ra...

Front Coil Springs for the front suspension, raising ride height by approximately 50mm over standard. Supplied as a pair. The raised height increa...

Rear Shock Absorber - a hydraulic damper for the rear suspension, controlling axle movement and wheel oscillation over uneven terrain. Matched to ...

Rear Coil Springs for the rear suspension, raising ride height by approximately 50mm over standard. Supplied as a pair. The raised height increase...

Cup Holder for the BA 189A centre cubby box. This is the replacement cup holder component for the current-design cubby box, providing a secured rec...

Air Conditioning Kit for retrofitting front air conditioning to TDCi Defenders that left the factory without it. Designed as an OE-style installat...

Adjustable Tow Drop Plate forms part of the towing hitch assembly, mounting between the chassis-fixed tow bar and the towball or coupling. The pla...

Tow Bar Armature Kit is the towing subframe that mounts to the rear chassis assembly. The subframe bolts to the vehicle's rear chassis members and...

Side Protection Tubes - a pair of tubular side rails in black-finished steel that mount along the lower body beneath the doors. They provide a ste...

Tow Bar Bracket - a fixed swan-neck tow bar that bolts to the vehicle's rear chassis mounting points to form the towing attachment. The swan-neck ...