Land Rover Discovery Parts

Brake Disc Splash Shield - front left-hand side, part of the front brake disc and caliper assembly. The shield mounts to the hub carrier behind th...

Primary Fuel Filter for the 3.0L V6 diesel engine. The primary filter sits in the front fuel supply line and removes contaminants and water from th...

Bumper Retainer Nut - a push-in retaining nut used in the front bumper, radiator grille and rear bumper assemblies. The retainer clips into a pres...

Oil Sump Gasket seals the oil pan (sump) to the cylinder block on the V6 diesel engine. It maintains an oil-tight joint at the base of the engine,...

Front spring pad for the front suspension strut and coil spring assembly. The pad is an elastomer insulator that seats between the end of the coil...

Glow Plug Control Unit - the switching and control module of the diesel pre-heat system, wired between the battery supply and the glow plugs. The ...

Exterior Door Mirror Glass - left-hand, flat - for the door mirror assembly. The replaceable flat glass fits the left-hand exterior mirror housing...

Bolt

Bolt for the exhaust system front section. This fastener secures the flanged joint between the exhaust manifold and the front pipe section, holdin...

Fuel Hose for the throttle housing on the 4.4L V8 petrol (AJ V8 EFI) engine. This moulded hose is routed at the throttle housing within the engine...

Timing Chain for the 2.0L 16V TiVCT turbocharged petrol engine (Si4 240PS and Gen2). It forms part of the engine's timing drive, running between th...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Anti-Roll Bar Bush for the suspension stabiliser system. This rubber insulator clamps the anti-roll bar to its mounting, locating the bar while all...

Rear Brake Pads - With Springs - friction pads for the rear disc brake assembly, supplied complete with the caliper pad retaining springs. The pad...

Oil Separator is the crankcase ventilation (PCV) oil separator for the 2.0L 16V turbocharged petrol engine. It sits in the crankcase breather circ...

Oil Filter - engine oil filter element for the 2.2L Td4 diesel engine, supplied with its sealing ring. The element fits inside the filter housing ...

Door Handle Gasket for the rear door. The gasket seals the rear door handle and lock cover against the door skin, preventing water ingress into th...

Holder - Cup

Cap

Brake Light Switch mounted at the brake pedal. Operated by the brake pedal, this switch signals the stop lamps to illuminate when the brakes are a...

Thermostat Housing - coolant outlet housing in the engine cooling circuit of the 2.2L Td4 diesel engine. The housing mounts to the engine and carr...

Thermostat Housing for the 2.0L Ingenium petrol engine (AJ200P, including PHEV applications). The housing holds the coolant thermostat and forms p...

Oil Cooler Return Connector is a connector fitting in the engine oil cooler circuit of the 2.2L diesel engine (DW12). It joins the oil cooler retu...

Bolt - M8 x 75mm secures the lower timing gear on the V6 diesel engine. It is a fastener within the timing gear drive assembly. Thread size M8, le...

Hose and Bracket - Heating

Actuator

Heater Pipe Kit - Air Con

Washer Bottle The reservoir that stores washer fluid for the windscreen and headlamp wash systems. The dual-wash bottle feeds both the windscreen w...

Coolant Hose serving the throttle housing on the 4.4L V8 petrol (AJ V8 EFI) engine. This hose carries engine coolant to the throttle housing, prov...

Holder - Cup

Radiator Cap - screw-on pressure cap for the coolant expansion tank in the engine cooling system. The cap seals the expansion tank and holds the c...

Fuel Injector Pressure Sensor - high-pressure fuel rail sensor in the direct-injection fuel supply circuit. It measures the fuel pressure in the i...

Oil Filter Housing Cover for the oil cooler and filter housing on the 2.2L DW12 turbo-diesel engine. The cover closes the oil filter housing, reta...

Thermostat for the engine cooling system on the 3.0L 24V DOHC V6 turbo diesel engine. It regulates coolant flow between the engine and radiator, s...

Thermostat & Housing is a combined coolant thermostat and housing assembly within the engine cooling system. The thermostat regulates coolant ...

Oil Feed Ring - mainshaft oil feed ring for the R380 five-speed manual gearbox. Located on the gearbox mainshaft, it channels lubricating oil to t...

Screw is a fixing screw used to secure exterior lamp, interior lamp and trim components to the body. It retains fittings such as the high-level st...

Spark Plug for the 4.4L V8 and 4.2L supercharged V8 petrol engines. It ignites the air/fuel mixture in the combustion chamber. One spark plug is r...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

EGR Tube connecting the exhaust manifold to the EGR valve on the 3.0L V6 turbo diesel engine. Carries hot exhaust gas from the exhaust manifold to...

Radiator Hose - Bottom for the 5.0L AJ133 V8 petrol engine, part of the cooling system pipes and hoses. The bottom hose returns cooled coolant fro...