Land Rover Series 1 Parts

Pinion Bearing Retaining Plate for the Power Take-Off (PTO) unit on Series Land Rovers. This retaining plate locates and secures the pinion bearin...

Stud used at the gearbox-to-chassis bracket mounting on Series models. A 7/16" BSF stud securing the gearbox mounting bracket to the chassis. Not ...

Sending is only possible by pallet. Too fragile for normal parcel delivery.

Door Checker Bracket Assembly - Rear - LH is the door check mechanism for the left-hand rear door. It links the door to the body pillar and limits...

Dynamo to Alternator Conversion

Static Lap Belt - a two-point lap seat belt for a centre or side-facing seating position. The webbing is a fixed length and is adjusted by hand to...

Layshaft Gear is the gear cluster carried on the layshaft (countershaft) of the manual gearbox. Its gears run in constant mesh with the mainshaft ...

Restore the structural integrity of your Defender 90/110 or Series SWB/LWB with this right-hand side (RHS) bulkhead repair panel, designed for dura...

Repair and restore the bulkhead structure of your Defender 90/110 or Series SWB/LWB with this left-hand side (LHS) bulkhead repair panel, designed ...

Sliding Window Kit - a pair of sliding side windows fitted with green-tinted toughened glass certified to E11 CE R-43. The sliding panes provide op...

Fuel Tank Fitting Kit - the mounting hardware used to secure the short-wheelbase fuel tank (part 552174) to the vehicle. Supplied for fitting or r...

Front Chassis Leg for the right-hand (offside) front of the chassis. A welded chassis repair section that renews the front chassis leg where the o...

Steel Wheel - a 5.5J x 16 pressed-steel rim finished in Limestone gloss. This is a tube-type rim: it is not sealed for tubeless running and must b...

Doortop Unglazed - Series - RH

Steel Ball - 9/32 inch steel ball used in the steering column assembly. Supplied individually. Ball diameter 9/32 inch (7.14 mm).

Protector Top Wing - Series

Halfshaft Retaining Collar fitted to the axle halfshaft to locate and retain the halfshaft bearing on the shaft. The collar is pressed onto the ha...

Screw - a set screw for the gearbox top cover plate. It secures the cover plate to the top of the main gearbox casing. Not used on the Stage 1 V8 ...

Flywheel Ring Gear for four-cylinder petrol engines. The ring gear is shrink-fitted to the periphery of the flywheel and meshes with the starter mo...

Mainshaft Gear - 1st Speed is a 29-tooth first-speed gear that runs on the mainshaft within the manual gearbox gear train. As a non-synchronised c...

Steel Ball for the timing chain tensioner, 7/32 in diameter. Seats within the tensioner mechanism to help maintain correct timing chain tension.

Hood Stick Kit - the framework of bows and sticks that forms the skeleton of a canvas soft top (tilt), carrying and tensioning the fabric over the ...

Pipe clamp 109" intermediate exhaust pipe centre bracket (For the bottom bracket use 264889.)

Valve Stem Oil Seal fits over the inlet valve stems to limit oil consumption past the valve guides in the cylinder head. It is used on 2.25L petrol...

Gear - 2nd - Pair for the Series Land Rover four-speed main gearbox. This pair comprises the matched 2nd speed gears for both the mainshaft and th...

Inner Pinion Bearing for the Land Rover Series axle differential, supporting the pinion shaft at the inboard (crown wheel) end within the different...

Transfer Box Mainshaft is the central rotating shaft within the transfer box assembly, running through the gear train and transmitting drive betwee...

Shim 0.005