Range Rover Evoque L551 Parts

Fuel Pressure Regulator fitted to the high-pressure diesel injection pump. The regulator controls the pressure of fuel delivered by the injection ...

Cylinder Head Gasket for the 2.0L I4 (AJ200 / AJ20D4) diesel engine. It seals the joint between the cylinder head and the engine block, sealing com...

Cylinder Head Gasket for the 2.0L I4 (AJ200 / AJ20D4) diesel engine. It seals the joint between the cylinder head and the engine block, sealing com...

Tyre Pressure Sensor - wheel-mounted sensor forming part of the Tyre Pressure Monitoring System (TPMS). The sensor is fitted at the valve position...

Front Crankshaft Oil Seal - radial lip seal in the cylinder block and front cover assembly, sealing the crankshaft nose where it passes through the...

Ignition Coil for the 2.0L four-cylinder petrol engine (AJ200 / AJ20P4, including PHEV). This is a coil-on-plug unit that mounts directly on the sp...

Output Shaft Oil Seal seals the transmission output shaft where it exits the case on the ZF 9HP48 / 9HP50 nine-speed automatic gearbox. It runs aga...

Axle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...

Axle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...

Flanged Nut with an integral flange that spreads the clamping load and helps resist loosening, removing the need for a separate washer. Used to se...

Brake Disc Retaining Screw that locates the brake disc against the wheel hub flange, holding the disc square and in position while the caliper and ...

Retaining Clip is a fastening clip used in the radiator grille and front bumper assembly. It secures the grille and front bumper trim components t...

Clip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.

Brake Caliper Guide Pin Dust Cover for the front and rear brake calipers. The boot fits over the caliper guide pin and seals against the carrier b...

Cylinder Head Gasket sealing the cylinder head to the engine block. Fitted to the 2.0L four-cylinder AJ200 (Ingenium) petrol engine, including PHE...

Parking Sensor is a Park Distance Control (PDC) ultrasonic sensor mounted in the bumper, part of the parking aid system. It emits and receives ult...

Fuel Filler Restrictor for diesel vehicles, fitted inside the fuel filler neck as part of the fuel tank and filler assembly. It forms a physical b...

Front Axle Output Seal - RH Outer - the outer oil seal on the right-hand output of the front axle case. It seals around the differential output fl...

Fuel Pressure Sensor for the high-pressure fuel injection circuit on petrol engines. It measures fuel rail pressure and temperature and reports to ...

Brake Pads for the rear axle, part of the rear brake discs and calipers assembly. The pads are clamped by the caliper pistons against both faces o...

Exhaust Gas Temperature Sensor monitors exhaust gas temperature within the exhaust and emissions system. Mounted on the exhaust manifold or turboc...

Primary Timing Chain Tensioner from the timing drive assembly at the front of the 2.0L four-cylinder AJ200 / AJ20P4 engine. The tensioner bears ag...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4), including plug-in ...

Sealing Ring - the right-hand outer seal for the front axle case, part of the front driveline. It seals the point where the front driveshaft passe...

Joint and Stub Shaft - the front-axle driveshaft joint and stub shaft assembly. Transmits drive from the front differential to the wheel hub, acco...

Output Shaft Oil Seal from the external components of the ZF 9HP48 / 9HP50 nine-speed automatic transmission. The seal fits around the gearbox out...

Front Brake Pad Set - Less Springs - friction pads for the front disc brake assembly, mounted in the front caliper and clamping the front brake dis...

Brake Pad Set for the front axle, sized for 18-inch brakes. The set provides the friction material that acts against the front brake discs. It is ...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder turbo diesel (AJ200D / AJ20D4). It runs in the up...

Knock Sensor for the engine management system, mounted on the rear face of the cylinder block. Petrol applications only - Ingenium AJ200P, AJ20P an...

Fuel Pressure and Temperature Sensor for petrol fuel-injection systems. The combined sensor measures fuel rail pressure and fuel temperature and r...

Timing Chain for the timing drive of the 2.0L Ingenium four-cylinder diesel engine (AJ200D / AJ20D4). This is the lower, primary chain of the two-...

Bumper Retainer Nut - a push-in retaining nut used in the front bumper, radiator grille and rear bumper assemblies. The retainer clips into a pres...

Bolt - M8 x 45 mm Torx-head flange bolt for the propshaft flange connection. The bolt secures the flange-type propshaft joint to the mating drive ...

Clutch Master Cylinder - the hydraulic actuator at the head of the clutch circuit, mounted on the pedal box. It converts clutch-pedal effort into h...

Glow Plug Control Unit - the switching and control module of the diesel pre-heat system, wired between the battery supply and the glow plugs. The ...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Servo Seal - rubber grommet fitted to the brake vacuum booster (servo) housing. It seals the connection into the booster body, maintaining the vac...

Front brake disc, 325mm diameter, internally vented, forming part of the front brake disc and caliper assembly. Mounted to the front hub, the disc...

Radiator Cap - screw-on pressure cap for the coolant expansion tank in the engine cooling system. The cap seals the expansion tank and holds the c...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

Wheel hub bearing for the front and rear knuckle and hub assemblies. The bearing carries vehicle load between the hub and the knuckle and allows t...