Range Rover Evoque Parts

Body Moulding Retainer Clip, a lantern-type fastener for the vehicle's exterior trim. The clip secures exterior body mouldings - such as the rocke...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Lamp - Side Flasher

Automatic Transmission Fluid (ATF) for the automatic gearbox and power steering circuit. Specified as the transmission and power steering fluid to...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Trim Clip - a plastic push-fit retaining clip used to secure exterior trim and body mouldings to the vehicle. It locates in a pre-drilled panel hol...

Plastic Rivet is a push-fit fastener that secures front engine-compartment insulation panels to the body. It locates into a pre-formed panel hole t...

Plastic Rivet is a push-fit fastener that secures front engine-compartment insulation panels to the body. It locates into a pre-formed panel hole t...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Cylinder Head Gasket seals the cylinder head to the engine block on the 2.0L Ingenium four-cylinder diesel engine (AJ200 series). It seals the com...

Cylinder Head Gasket seals the cylinder head to the engine block on the 2.0L Ingenium four-cylinder diesel engine (AJ200 series). It seals the com...

Drive Chain Idler - timing gear idler sprocket for the 2.0L four-cylinder Ingenium engine family (AJ200 / AJ20 series, petrol and diesel). The idl...

Automatic Transmission Fluid (ATF), supplied in a 1 litre container. Specified for the automatic transmission and, where applicable, the power ste...

Automatic Transmission Fluid (ATF), supplied in a 1 litre container. Specified for the automatic transmission and, where applicable, the power ste...

Cylinder Head Bolt Kit for the 2.0L Ingenium diesel engine (AJ200 / AJ20D4). Supplied as a set for renewing the cylinder head bolts when the cylin...

Cylinder Head Bolt for the 2.0L Ingenium diesel engine (AJ200 / AJ20D4), securing the cylinder head to the engine block. Supplied as a single bolt...

Fuel Pressure Sensor mounted in the fuel supply manifold (common rail). The sensor measures the pressure of fuel in the rail and reports it to the...

Diesel Exhaust Fluid (AdBlue) for diesel vehicles fitted with a selective catalytic reduction (SCR) exhaust after-treatment system. The fluid is h...

Fuel Pressure Regulator (fuel pressure control valve) for the diesel high-pressure fuel injection system. Mounted on the high-pressure fuel pump, i...

Fuel Pressure Regulator fitted to the high-pressure diesel injection pump. The regulator controls the pressure of fuel delivered by the injection ...

Cylinder Head Gasket for the 2.0L I4 (AJ200 / AJ20D4) diesel engine. It seals the joint between the cylinder head and the engine block, sealing com...

Cylinder Head Gasket for the 2.0L I4 (AJ200 / AJ20D4) diesel engine. It seals the joint between the cylinder head and the engine block, sealing com...

Ignition Coil for the 2.0L four-cylinder petrol engine (AJ200 / AJ20P4, including PHEV). This is a coil-on-plug unit that mounts directly on the sp...

Immobiliser Transceiver for the vehicle anti-theft (immobiliser) system. This is the transceiver aerial that reads the transponder in the key at t...

Axle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...

Axle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...

Brake Disc Retaining Screw that locates the brake disc against the wheel hub flange, holding the disc square and in position while the caliper and ...

Retaining Clip is a fastening clip used in the radiator grille and front bumper assembly. It secures the grille and front bumper trim components t...

Clip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.

Brake Caliper Guide Pin Dust Cover for the front and rear brake calipers. The boot fits over the caliper guide pin and seals against the carrier b...

Cylinder Head Gasket sealing the cylinder head to the engine block. Fitted to the 2.0L four-cylinder AJ200 (Ingenium) petrol engine, including PHE...

Parking Sensor is a Park Distance Control (PDC) ultrasonic sensor mounted in the bumper, part of the parking aid system. It emits and receives ult...

Keyless Entry and Start Aerial is the receiver antenna for the passive keyless entry and push-button start system, part of the vehicle's anti-theft...

Brake Disc & Caliper Bolt - a fixing bolt for the brake disc and caliper assembly. It is used at both the front and rear brake disc and calipe...

Brake Disc & Caliper Bolt - a fixing bolt for the brake disc and caliper assembly. It is used at both the front and rear brake disc and calipe...

LED Mirror Indicator Kit - a pair of direction indicator modules that replace the original repeater units in the door mirror housings. The modules...

Fuel Pressure Sensor for the high-pressure fuel injection circuit on petrol engines. It measures fuel rail pressure and temperature and reports to ...

Primary Timing Chain Tensioner from the timing drive assembly at the front of the 2.0L four-cylinder AJ200 / AJ20P4 engine. The tensioner bears ag...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4), including plug-in ...

Lamp - Side Flasher