Range Rover Evoque Parts

Nut - an M8 x 1.25 captive U-spring nut used to mount the air suspension compressor. The spring-steel body clips over the chassis bracket to provi...

Fuel Pump Drive Control module within the fuel delivery system, governing operation of the in-tank fuel pump. The module receives a demand signal ...

Fuel Pump Drive Control module within the fuel delivery system, governing operation of the in-tank fuel pump. The module receives a demand signal ...

High Voltage Water Heater for plug-in hybrid (PHEV) applications, operating in the high-voltage coolant heating circuit. The unit heats engine coo...

Crankcase Breather Cover - crankcase ventilation cover on the 2.0L AJ20P4 petrol engine, forming part of the crankcase emission control assembly. ...

Coolant Degas Separator, part of the engine cooling circuit on 2.0L Ingenium (AJ200) petrol applications. The degas separator removes entrained ai...

Wheel hub bearing for the front and rear knuckle and hub assemblies. The bearing carries vehicle load between the hub and the knuckle and allows t...

Front Brake Pads for the front axle disc brake assembly, supplied as a full axle set covering both front calipers. The friction pads are clamped a...

Purge Control Valve - evaporative emission (EVAP) control system. The valve sits in the line between the activated carbon canister and the engine ...

Balance Shaft - counterweighted shaft forming part of the engine balancer assembly in the lower block. Driven from the crankshaft and running at t...

Suspension Arm - Front - LH - front suspension arm (wishbone) in the front independent suspension assembly, left-hand side. The arm locates the fr...

Suspension Arm - Front - RH - front suspension arm (wishbone) in the front independent suspension assembly, right-hand side. The arm locates the f...

Brake Pad Set - Front - friction pad set for the front brake caliper assembly, part of the foundation braking system. Supplied in the less-springs...

Rear Brake Disc - 325 mm solid disc for the rear axle service brake assembly. The disc locates on the rear wheel hub flange and forms the friction...

Rear Brake Disc - 300 mm solid disc for the rear axle service brake assembly. The disc locates on the rear wheel hub flange and forms the friction...

Front brake disc, 349mm diameter, internally vented, forming part of the front brake disc and caliper assembly. Mounted to the front hub, the disc...

Drive Belt Tensioner - automatic tensioner for the front-end accessory drive on the AJ20 Ingenium petrol engine range. A spring-loaded pivoting ar...

Brake Pads for the rear axle, part of the rear brake discs and calipers assembly. The pads are clamped by the caliper pistons against both faces o...

Rear Brake Pad Kit - friction pads for the rear disc brake assembly, mounted in the rear caliper and clamping the rear brake disc. Supplied as a r...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Glow Plug Control Unit - the switching and control module of the diesel pre-heat system, wired between the battery supply and the glow plugs. The ...

Tailgate Latch is the closure latch of the tailgate / luggage compartment lock controls. It engages the body-mounted striker to hold the tailgate ...

Idler Pulley for the accessory drive belt system, mounted on the front of the engine within the auxiliary belt run. The idler pulley drives nothin...

Front Shock Absorber for the front suspension damper assembly. The damper controls oscillation of the front coil spring, damping wheel and body mo...

Front Crankshaft Oil Seal - radial lip seal in the cylinder block and front cover assembly, sealing the crankshaft nose where it passes through the...

Kit - Gear Shift Trigger

Coolant Expansion Tank - the header and overflow reservoir of the engine cooling circuit, mounted alongside the radiator. The tank absorbs the vol...

Wheel Cover for the road wheel. The cover fits over the wheel to give a finished appearance and shield the wheel face from road dirt and brake dus...

Wheel Cover set, fitted over the road wheels. The covers clip over the wheels to give a finished appearance and shield the wheel face from road di...

Timing Chain Tensioner for the 2.0L Ingenium petrol engine (AJ200P). Maintains running tension on the timing chain, taking up slack to keep valve ...

Air Conditioning Compressor

Solenoid Switch for the centre console switch pack, serving as the engine start-stop control. Mounted in the console and facia switchgear, it sign...

Fuel Filler Restrictor for diesel vehicles, fitted inside the fuel filler neck as part of the fuel tank and filler assembly. It forms a physical b...

Trim Clip that secures interior and exterior trim panels, door finishers and mouldings to the body. The clip locates in a pre-formed panel apertur...

Bonnet Latch for the bonnet (hood) closure mechanism. It engages the bonnet striker to hold the bonnet closed and releases it when operated, formin...

Bearing Holder - front bearing housing within the Front Axle Drive Shaft assembly. The holder carries and retains the front support bearing of the...

Screw and Washer - M5 x 20 is a self-tapping fastener with a captive washer, an M5 thread, 20 mm length and a hex head. It secures body panels, sp...

Relay Black 2A 4 Pin

Pollen Filter for the heater and ventilation assembly. This cabin air filter installs within the heater assembly, filtering the air drawn into the...