Range Rover Evoque Parts

A-Pillar Finisher - Outer is the exterior trim finisher fitted to the outer A-pillar, giving the pillar its finished external appearance where the ...

Exhaust Pipe Gasket for the front exhaust section of the 2.0L turbocharged petrol engine. Seals the flanged front pipe to catalyst joint, providin...

Oil Drain Plug for the 2.0L 16V petrol engine. It seals the drain point in the oil pan (sump) and is removed to drain the engine oil at a service.

Timing Gear Bolt for the 2.0L 16V petrol engine. It secures a gear on the engine's timing drive.

Valve Spring Retainer for the 2.0L 16-valve turbocharged petrol engine, fitted in the cylinder head valve train. The retainer caps the top of the ...

Crankshaft Damper Washer for the 2.0L 16-valve turbocharged petrol engine, fitted in the crankshaft damper assembly at the front of the timing gear...

Drive Chain Idler - timing gear idler sprocket for the 2.0L four-cylinder Ingenium engine family (AJ200 / AJ20 series, petrol and diesel). The idl...

Oil Filter Adaptor Gasket for the 2.0L 16-valve turbocharged petrol engine, sealing the oil cooler and filter adaptor to the engine. The gasket fo...

Accessory Drive Pulley Bolt for the 2.0L 16-valve turbocharged petrol engine, used in the accessory drive belt system. The bolt secures the access...

Windscreen Washer Reservoir stores the washer fluid supply for the screen wash system and, on this variant, the headlamp power wash jets. This res...

Engine Mounting Bolt with hexagonal head, M12 x 112 mm. A structural fastener securing the engine mounting to the subframe; the same bolt is also ...

Upper Knuckle Bolt is a hex-head bolt that retains the upper knuckle joint within the hub and knuckle assembly. It clamps the upper knuckle to the...

Coolant Degas Hose is part of the engine cooling system's degas (deaeration) circuit. It carries coolant and entrained air between the engine or r...

High Pressure Fuel Pump Tappet drives the engine-mounted high-pressure fuel pump from the camshaft. The tappet acts as the cam follower, riding on...

Name Plate is a moulded plastic exterior badge fitted to the body panel.

Front Brake Hose - flexible hydraulic hose in the front brake circuit, left-hand side. It carries brake fluid from the rigid pipe on the body to t...

Front Brake Hose - flexible hydraulic hose in the front brake circuit, right-hand side. It carries brake fluid from the rigid pipe on the body to ...

Diesel Exhaust Fluid (AdBlue) for diesel vehicles fitted with a selective catalytic reduction (SCR) exhaust after-treatment system. The fluid is h...

EGR Cooler Gasket for the 2.2L diesel engine, part of the exhaust gas recirculation (EGR) system. Seals the joint between the exhaust manifold and...

Cover - Mirror Housing

Transmission Oil, 1 litre. Hydraulic fluid specified for the automatic transmission and power steering system. Maintains the hydraulic pressure an...

Front Windscreen Wiper Blade Kit for the front wash/wipe system, supplied as a matched two-piece set for right-hand-drive vehicles. The kit contai...

Coolant Hose forms part of the engine cooling circuit, carrying coolant between the cooling-system components. Moulded to suit the 2.0L 16V turboc...

Axle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...

Breather Valve for the axle case or manual transmission housing. The valve vents the housing to atmosphere, allowing internal air pressure to equa...

Accessory Drive Idler Pulley - Lower in the front end accessory drive (FEAD) belt system of the 2.0L 16V turbocharged petrol engine. The lower idl...

Heater Hose for the engine cooling and cabin heating circuit. This hose carries heated engine coolant between the engine and the heater matrix, wh...

Number Plate Bracket for the rear of the vehicle, mounting the registration plate to the luggage compartment door (tailgate). The bracket holds th...

Battery Management System sensor for the negative battery terminal, forming part of the vehicle's battery monitoring and charge-control circuit. I...

Retaining Clip is a fastening clip used in the radiator grille and front bumper assembly. It secures the grille and front bumper trim components t...

Clip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.

Cylinder Head Gasket sealing the cylinder head to the engine block. Fitted to the 2.0L four-cylinder AJ200 (Ingenium) petrol engine, including PHE...

Shock Absorber Top Mount for the front strut assembly. The top mount secures the upper end of the front strut to the vehicle body, isolating suspe...

Brake Disc & Caliper Bolt - a fixing bolt for the brake disc and caliper assembly. It is used at both the front and rear brake disc and calipe...

Coolant Hose from the EGR cooler to the heater inlet, part of the engine cooling and exhaust gas recirculation circuit. The EGR cooler is coolant-...

Sealing Ring - oil seal at the input of the AWF21 six-speed automatic transmission, sealing around the torque converter hub where it enters the tra...

Exhaust Gasket for the flanged joint between the exhaust front pipe and the catalyst section. It seals the bolted flange where the front pipe meet...

Air Conditioning O-Ring - a sealing ring for the air conditioning refrigerant circuit. It seals the joints between refrigerant lines and component...