Range Rover Evoque Parts

Sealing Ring - the right-hand outer seal for the front axle case, part of the front driveline. It seals the point where the front driveshaft passe...

Lamp - Side Flasher

Thermostat and Housing assembly for the 2.0L 16V TIVCT turbocharged petrol (GTDi) engine. The thermostat regulates coolant flow to bring the engine...

Washer Bottle Filler Cap - the filler cap for the windscreen washer fluid reservoir. It closes the reservoir filler neck, sealing the washer fluid...

Front Brake Pad Set - friction pads for the front disc brake assembly. The pads locate in the front caliper and are clamped against the brake disc...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder turbo diesel (AJ200D / AJ20D4). It runs in the up...

Fuel Filter - diesel fuel filter for the 2.2L Td4 engine, fitted in the low-pressure fuel supply circuit. The filter sits between the fuel tank an...

Engine Mount Insulator is the rear lower engine mounting within the engine support system. It locates the engine to the subframe and isolates engi...

Rear Brake Disc, solid type, 302mm diameter, forming part of the rear axle braking assembly. The disc provides the friction surface for the rear b...

Coolant Hose Assembly - heater outlet to thermostat housing hose in the engine cooling circuit. Returns coolant from the heater matrix outlet to t...

Fuel Pressure and Temperature Sensor for petrol fuel-injection systems. The combined sensor measures fuel rail pressure and fuel temperature and r...

Timing Chain for the timing drive of the 2.0L Ingenium four-cylinder diesel engine (AJ200D / AJ20D4). This is the lower, primary chain of the two-...

Bumper Retainer Nut - a push-in retaining nut used in the front bumper, radiator grille and rear bumper assemblies. The retainer clips into a pres...

Bolt for the exhaust system front section. This fastener secures the flanged joint between the exhaust manifold and the front pipe section, holdin...

Anti-Roll Bar Bush for the suspension stabiliser system. This rubber insulator clamps the anti-roll bar to its mounting, locating the bar while all...

Oil Separator is the crankcase ventilation (PCV) oil separator for the 2.0L 16V turbocharged petrol engine. It sits in the crankcase breather circ...

Oil Filter - engine oil filter element for the 2.2L Td4 diesel engine, supplied with its sealing ring. The element fits inside the filter housing ...

Front Brake Disc - 300 mm vented, supplied singly; two are required to do the front axle. The vented construction carries internal vanes between t...

Thermostat Housing - coolant outlet housing in the engine cooling circuit of the 2.2L Td4 diesel engine. The housing mounts to the engine and carr...

Thermostat Housing for the 2.0L Ingenium petrol engine (AJ200P, including PHEV applications). The housing holds the coolant thermostat and forms p...

Oil Cooler Return Connector is a connector fitting in the engine oil cooler circuit of the 2.2L diesel engine (DW12). It joins the oil cooler retu...

Grommet - a moulded rubber grommet fitted into an aperture in the body. It lines and seals the opening, providing a finished edge and helping to k...

Radiator Cap - screw-on pressure cap for the coolant expansion tank in the engine cooling system. The cap seals the expansion tank and holds the c...

Oil Filter Housing Cover for the oil cooler and filter housing on the 2.2L DW12 turbo-diesel engine. The cover closes the oil filter housing, reta...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

Coolant Expansion Tank is the reservoir within the engine cooling system. It accommodates coolant expansion as temperature rises, provides a fill ...

Rear Brake Pad Set - friction pads for the rear disc brake assembly, supplied as a rear axle set complete with springs. The pads locate in the rea...

Lower Engine Mount (engine support insulator) securing the engine at its lower mounting point. It carries the lower engine load and damps engine v...

Engine Start/Stop Switch - the push-button ignition switch of the keyless start system. Pressing the button powers up and starts or stops the engi...

Seal - Door Front and Rear

Cigar Lighter Base - the socket housing for the cigar lighter and 12V auxiliary power point. It mounts in the instrument panel or floor console and...

Fuel Tank Vent Reservoir for the evaporative emission control (EVAP) system on petrol models. It collects and stores fuel vapour drawn from the fue...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Driveshaft Retainer Circlip locks the inner end of the front driveshaft into the differential inside the front axle case. The clip springs into a ...

Driveshaft Oil Seal - Inner - Front LH is fitted to the front axle case (final drive housing) and seals around the inner end of the left-hand front...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...

Oil Seal - Differential Flange - Front seals the front differential where the drive flange exits the axle case. It runs against the differential o...

Cylinder Head Gasket for the 2.0L 16V TiVCT turbocharged petrol engine, sealing the joint between the cylinder head and the engine block. It conta...

Transmission Oil - Hypoid is a hypoid gear oil for the Power Transfer Unit (PTU) / transfer box. It lubricates the hypoid gearset that sends drive...