Range Rover Evoque Parts

screw M5 x 12

Blind Rivet Pin is a plastic blind-rivet fastener, 9.4 mm head diameter by 13 mm long. It secures trim panels, covers and liners by expanding to g...

Relay - 20A 5-pin black micro-format relay for use in vehicle fuse and relay centres. The 5-pin configuration provides both normally-open and norm...

Starter Motor - Defender TD4

Key Fob Battery - CR2032 3V lithium button cell for Land Rover remote central locking handsets. Fits directly into the remote key fob housing. Rep...

Coolant Temperature Sensor in the engine cooling circuit. This sensor monitors coolant temperature and transmits a signal to the engine management...

Exhaust Gas Pressure Sensor for the diesel particulate filter (DPF) circuit on the 2.0L I4 AJ200D diesel engine. The sensor measures exhaust gas p...

Knock Sensor mounts on the cylinder block and detects engine knock through block vibration. It reports combustion knock to the engine management s...

Exhaust Gas Pressure Sensor mounted in the front pipe / catalyst section of the exhaust system. The sensor measures exhaust gas pressure and repor...

Front Brake Pad Wear Sensor monitors friction-material thickness at the front axle. As the brake pads approach their wear limit, the sensor circuit...

Front Brake Pad Wear Sensor for the front axle brake assembly, part of the brake pad wear warning circuit. The sensor consists of a wire loop seat...

Front Brake Pad Wear Sensor Wire from the front brake pad wear warning circuit. The sensor wire is routed into a slot in the front brake pad frict...

Coolant Temperature Sensor mounted in the cylinder head coolant gallery, part of the engine cooling and engine management system. The sensor is a ...

Oil Pressure Switch from the engine lubrication system. The switch threads into an oil gallery and monitors lubricating oil pressure, signalling t...

Ceramic Glow Plug - cold-start heating element from the diesel pre-heat system, threaded into the cylinder head with the tip projecting into the co...

Exhaust Gas Pressure Sensor for the diesel exhaust aftertreatment system. The sensor is connected by take-off pipes to the exhaust upstream and do...

Front Brake Pad Wear Sensor Wire from the front brake pad wear warning circuit. The sensor wire is routed into a slot in the front brake pad frict...

Camshaft Position Sensor for the 2.0L TiVCT turbocharged petrol engine. Mounted at the cylinder head, this sensor monitors camshaft rotational pos...

Knock Sensor mounts on the cylinder block and detects engine knock through block vibration. It reports combustion knock to the engine management s...

TMAP Sensor is the combined intake air temperature and manifold absolute pressure sensor, fitted to the inlet manifold and intercooler ducting. It...

MAP Sensor is the manifold absolute pressure and charge-air temperature sensor mounted in the inlet manifold. It reports intake manifold pressure ...

Camshaft Position Sensor for the 2.0L TiVCT turbocharged petrol engine. Mounted at the cylinder head, this sensor monitors camshaft rotational pos...

Fuse installs within the electrical power distribution system, protecting a circuit against overcurrent by interrupting the supply when the rated c...

Remote Control Receiver forms part of the anti-theft alarm system, receiving the radio signal transmitted by the remote key fob. It relays the loc...

Wiper Blade clears the front windscreen as part of the wash/wipe system. It is the front blade fitted to the left-hand wiper arm, sweeping the pas...

Wiper Blade for the front windscreen, part of the wash/wipe system on left-hand-drive vehicles. It clears rain and road spray from the windscreen ...

Wiper Blade for the front windscreen, fitted to the left-hand wiper arm on left-hand-drive vehicles. It forms part of the windscreen wash/wipe sys...

Wiper Blade clears the front windscreen as part of the wash/wipe system. It is the front blade fitted to the right-hand wiper arm, sweeping the dr...

Temperature Sensor monitors engine coolant temperature from its mounting in the cylinder block, within the Cylinder Block and Plugs assembly. The ...

Wire - Brake Pad Wear Warning

Battery - 12V lead-acid battery of flooded, non-spillable construction, for the vehicle low-voltage electrical supply. Non-spillable construction ...

Lambda Sensor - exhaust gas oxygen sensor operating within the exhaust aftertreatment and diesel particulate filter group. The sensor measures the...

Tyre Pressure Sensor - wheel-mounted sensor forming part of the Tyre Pressure Monitoring System (TPMS). The sensor is fitted at the valve position...

Knock Sensor for the engine management system, mounted on the rear face of the cylinder block. Petrol applications only - Ingenium AJ200P, AJ20P an...

Exhaust Gas Pressure Sensor for the diesel particulate filter, in the exhaust aftertreatment sensing group. Connected by pressure pipes across the...

Oxygen Sensor (lambda sensor) for the lower, post-catalyst position in the exhaust gas sensing circuit, mounted in the exhaust front pipe at the ca...

Relay is a 4-pin electromechanical switching relay used within the vehicle's electrical system. A low-current control signal energises the 12V coi...

Valve - Control

Lambda Sensor - exhaust gas oxygen sensor in the exhaust after-treatment system of the 2.0L Ingenium diesel engine (AJ200D / AJ20D4), working with ...

Rear Wiper Blade for the tailgate window. It fits onto the rear wiper arm and sweeps the rear screen to maintain visibility through the tailgate gl...

Parking Aid Sensor is an ultrasonic Park Distance Control (PDC) sensor mounted in the bumper. It emits and receives ultrasonic pulses to measure t...

Parking Aid Sensor is an ultrasonic Park Distance Control (PDC) sensor mounted in the bumper. It emits and receives ultrasonic pulses to measure t...