Range Rover Evoque Parts

Timing Cover Blanking Plug - threaded plug that closes an aperture in the front timing cover of the 2.0L Ingenium petrol engine (AJ200 / AJ20P4, al...

Hypoid Differential Oil - SAE 75W-90 gear oil for final drive differentials and other hypoid gear applications. Formulated for the high sliding co...

O-Ring - VVT Solenoid Cover, 47 mm, sealing the variable valve timing solenoid cover to the cylinder head on Ingenium engines - 2.0L AJ20P and AJ20...

Coolant Temperature Sensor mounted in the cylinder head coolant gallery, part of the engine cooling and engine management system. The sensor is a ...

Cable Connector - an electrical connector used in the vehicle wiring harness. The connector forms the termination between a harness cable and its ...

Front Brake Sensor Wiring Bracket - mounting bracket for the brake pad wear sensor lead at the front disc brake and caliper assembly. The bracket ...

Rear Shock Absorber - hydraulic damper for the rear suspension, fitted between the body mounting point and the rear suspension arm. The damper con...

Cabin Pollen Filter, 272x195x43mm - the filter element in the HVAC intake housing, installed upstream of the blower motor and evaporator. All air ...

Coolant Bypass Tube - a rigid coolant transfer pipe in the cooling circuit of the 2.0L AJ20P4 four-cylinder petrol engine. The tube carries coolan...

Front Wiper Blade - Driver's Side is the driver's side blade of the front windscreen wiper system in left-hand drive configuration. It is the long...

Mini Relay with four blade terminals, rated at 40 amp. A four-terminal mini relay switches a single normally-open high-current circuit under the c...

Glow Plug - the pre-heat element for one cylinder of the 2.0L four-cylinder AJ200 / AJ20D4 diesel engine, threaded into the cylinder head so its ti...

Mini Relay with four blade terminals, rated at 70 amp, grey housing. A four-terminal mini relay switches a single normally-open high-current circu...

Front Wiper Blade for the windscreen wiper system, mounting to the wiper arm on the passenger side of left-hand drive vehicles. The blade carries ...

Oil Pressure Switch from the engine lubrication system. The switch threads into an oil gallery and monitors lubricating oil pressure, signalling t...

Glow Plug - cold-start pre-heating system of the 2.0L Ingenium AJ200 four-cylinder turbo diesel engine. Threads into the cylinder head, one per cy...

Screw - threaded fastener used in body and chassis assembly.

Front Brake Pad Wear Sensor for the front axle brake assembly, forming part of the brake pad wear warning circuit. The sensor is a wire loop carri...

O-Ring - VVT Solenoid Cover, 47 mm, sealing the variable valve timing solenoid cover to the cylinder head on Ingenium engines - 2.0L AJ20P and AJ20...

Rear shock absorber for the rear suspension assembly, for applications without adaptive damping. The damper controls oscillation of the rear sprin...

Valve stem seal for the cylinder head valve train. The seal locates on the valve guide and wipes the valve stem as it reciprocates, metering the s...

Front Wiper Blade - Driver's Side is the driver's side blade of the front windscreen wiper system in left-hand drive configuration. It is the long...

Drive Belt for the belt-driven starter generator (BSG) drive at the front of the engine. The belt transmits torque between the crankshaft pulley a...

Ceramic Glow Plug - cold-start heating element from the diesel pre-heat system, threaded into the cylinder head with the tip projecting into the co...

Timing Chain Guide, Lower Primary from the front timing gear assembly. It bears against the primary drive chain on the run between the crankshaft ...

Exhaust Clamp for the 2.0L Ingenium diesel exhaust system (AJ200D / AJ20D4). The clamp secures the front section joint of the exhaust, holding the...

Mini Relay with four blade terminals, rated at 70 amp, grey housing. A four-terminal mini relay switches a single normally-open high-current circu...

Cabin Pollen Filter, 272x195x43mm - the filter element in the HVAC intake housing, installed upstream of the blower motor and evaporator. All air ...

Timing Cover Blanking Plug - threaded plug that closes an aperture in the front timing cover of the 2.0L Ingenium petrol engine (AJ200 / AJ20P4, al...

Anti-Roll Bar Link - Front, the connecting link between the front anti-roll bar end and the suspension strut in the front suspension assembly. The...

Glow Plug - the pre-heat element for one cylinder of the 2.0L four-cylinder AJ200 / AJ20D4 diesel engine, threaded into the cylinder head so its ti...

Timing Gear Bolt - special-form fastener used in the timing drive assembly at the front of the Ingenium petrol engine. It is one of the fixings th...

Coolant Hose - Overflow - moulded hose in the engine cooling system, forming part of the overflow circuit between the cooling circuit and the coola...

Front Shock Absorber Insulator from the front suspension strut assembly. It sits at the spring seat between the coil spring and the strut, isolati...

Exhaust Gas Pressure Sensor for the diesel exhaust aftertreatment system. The sensor is connected by take-off pipes to the exhaust upstream and do...

Cabin Pollen Filter, 272x195x43mm - the filter element in the HVAC intake housing, installed upstream of the blower motor and evaporator. All air ...

Timing Chain Tensioner Arm is the pivoting guide arm in the timing drive of the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4 / AJ200P ...

Cylinder Head Bolt for Ingenium petrol engines (1.5L AJ20P3, 2.0L AJ200 / AJ20P4, 3.0L AJ20P6 / AJ22P6). The bolt clamps the cylinder head to the ...

EGR Inlet Gasket for the 2.0L AJ200 Ingenium diesel Exhaust Gas Recirculation system. Seals the inlet joint of the EGR assembly to maintain a gas-...

Cylinder Head Gasket for the 2.0L Ingenium four-cylinder petrol engine (AJ200 / AJ20P4). The gasket seals the joint between the cylinder head and ...

Knock Sensor mounts on the cylinder block and detects engine knock through block vibration. It reports combustion knock to the engine management s...