Range Rover Sport L494 Parts

Brake Light Switch RR Sport 05-09 Disco3 05-09

Brake Light Switch - pedal-mounted stop lamp switch, located on the brake pedal box assembly. The switch mounts on the pedal bracket and is actuat...

Asy Lamp

Nut and Washer Assembly is an M6 hexagonal nut supplied together with its washer as a single assembly. The washer spreads the clamping load across...

Front Brake Pad Set - friction pads for the front disc brake assembly. The pads locate in the front caliper and are clamped against the brake disc...

Wheel Centre Cap - hub cover for modular steel road wheels. It press-fits into the centre bore of the wheel, covering the hub flange and keeping d...

Timing Gear Bolt - Lower is the M16 x 70mm flanged hex bolt that retains the lower timing gear on the crankshaft. It is also listed as the cranksha...

Timing Gear Bolt - Lower is the M16 x 70mm flanged hex bolt that retains the lower timing gear on the crankshaft. It is also listed as the cranksha...

Front Brake Pad Set - friction pads for the front disc brake assembly. The pads locate in the front caliper and are clamped against the brake disc...

Front Brake Pad Set - Ceramic Friction pads for the front disc brake assembly, using a ceramic-based friction compound. The pads locate in the fro...

Diesel Exhaust Fluid (AdBlue) for diesel vehicles fitted with a selective catalytic reduction (SCR) exhaust after-treatment system. The fluid is h...

Blind Anchor Nut - a threaded anchor nut that provides a captive fixing point where the reverse side of the panel is inaccessible. It is used in t...

Size/Diameter: M8 10.9

Oil Sump Gasket seals the oil pan (sump) to the cylinder block on the V6 diesel engine. It maintains an oil-tight joint at the base of the engine,...

Bolt

Bolt - M8 x 75mm secures the lower timing gear on the V6 diesel engine. It is a fastener within the timing gear drive assembly. Thread size M8, le...

Fuel Injection Pump Bolt secures the high-pressure fuel injection pump to its mounting on the engine. It provides the clamping load that holds the...

Flanged Hex Bolt M10 x 25mm - a threaded fastener used in the engine timing gear and turbocharger mounting assemblies. The integral flange under t...

Glove Box Door Damper. Controls the rate at which the glove box lid opens, providing a smooth, damped movement within the facia glove box assembly.

Auxiliary Water Pump - electric coolant circulation pump for the fuel-fired booster heater circuit. The pump draws coolant through the fuel-burnin...

Oil Seal for the ZF transfer case. Seals a rotating shaft on the transfer case to retain lubricant and exclude contaminants.

Cylinder Block Core Plug Seal sealing a core plug aperture in the cylinder block. It seals a casting core plug opening in the block, preventing co...

Sensor - High Low Position - Tripminder

Electronic Pressure Control Solenoid for the transfer case control circuit. The solenoid is actuated electrically by the vehicle's control module ...

EGR Outlet Gasket seals the outlet joint of the exhaust gas recirculation (EGR) assembly. Fitted to the 3.0L V6 diesel (TDV6) engine, it forms a g...

Relay is a 4-pin electromechanical switching relay used within the vehicle's electrical system. A low-current control signal energises the 12V coi...

Front timing belt kit for the 2.7L and 3.0L V6 turbo diesel engine - the lower belt of the camshaft timing drive. The belt is driven from the cran...

Inlet Valve for the cylinder head valvetrain on 2.7, 3.0 TDV6 and 3.6, 4.4 TDV8 diesel engines. The inlet valve seats in the cylinder head and con...

Valve Stem Seal for the cylinder head valvetrain on TDV6 and TDV8 diesel engines. Fitted to both inlet and exhaust valves, the seal presses onto th...

Valve Stem Seal for the cylinder head valvetrain on TDV6 and TDV8 diesel engines. Fitted to both inlet and exhaust valves, the seal presses onto th...

Valve Stem Seal for the cylinder head valvetrain on TDV6 and TDV8 diesel engines. Fitted to both inlet and exhaust valves, the seal presses onto th...

Exhaust Manifold Stud for TDV6 2.7 and 3.0 and TDV8 3.6 diesel engines, used to fasten the exhaust manifold to the cylinder head. On 2.7 TDV6 engi...

Exhaust Manifold Stud for TDV6 2.7 and 3.0 and TDV8 3.6 diesel engines, used to fasten the exhaust manifold to the cylinder head. On 2.7 TDV6 engi...

Oil Separator Seal - sealing gasket for the oil separator in the crankcase ventilation system of the 2.7 and 3.0 litre V6 diesel engines. The oil ...

Oil Pump Seal for the V6 diesel engine oil pump assembly, part of the engine lubrication circuit. It seals the oil pump interface to prevent oil l...

Camshaft Pulley Hub mounts to the front of the right-hand (RH) cylinder bank camshaft on the 2.7L and 3.0L V6 diesel engine, forming part of the ti...

Timing Chain & Tensioner Kit - Upper

Oil Pump for the engine lubrication system. Driven by the engine, it draws oil from the sump and delivers it under pressure through the oil galler...

Head Gasket Set for the AJ133 5.0L V8 petrol engine in naturally aspirated form, covering the cylinder head to cylinder block joint. The head gask...

Camshaft Seal for the TDV6 2.7L V6 diesel engine. Seals the camshaft at its exit point from the cylinder head, preventing oil leakage from the cams...