Range Rover Sport L494 Parts

Bonnet Gas Strut for the bonnet lift mechanism. The gas-charged strut raises and supports the bonnet as it is opened and holds it securely in the r...

Water Outlet Connection sits at the engine coolant outlet within the cooling circuit, directing coolant from the engine into the connected hoses an...

Anti-Roll Bar Link - connects the rear anti-roll (stabilizer) bar to the suspension on the left-hand side. This drop link transfers body-roll load...

Gasket - Throttle

Degas Hose for the engine cooling system's degassing circuit. The hose routes coolant and entrained air from the engine and radiator to the degas (...

O-Ring Kit - a set of eight O-ring seals for the heater and air-conditioning unit. The kit provides the sealing O-rings needed when servicing or r...

Ignition Coil for V6 and V8 petrol engines, mounted directly on the spark plug in a coil-on-plug arrangement. The coil steps up the battery supply...

Anti-Roll Bar Bush - Front is a rubber insulator that mounts the front anti-roll (stabiliser) bar to the vehicle body. Working together with its m...

Lower Inlet Manifold Gasket for the supercharged 3.0L V6 petrol engine. It seals the lower section of the inlet manifold to the cylinder head, seal...

Nut and Retainer - an M10 nut with a captive retainer used at the front crossmember of the front suspension. The retainer locates and holds the nu...

Radiator Ventilation Hose for the engine cooling system's degassing circuit. The hose vents air and coolant vapour from the top of the radiator to ...

Idler Pulley for the secondary drive belt circuit on supercharged petrol engines. The idler is a freely-rotating, sealed-bearing pulley that guide...

Inlet Manifold Gasket for the right-hand cylinder bank, sealing the inlet manifold to the cylinder head. Seals the joint between the inlet manifol...

Inlet Manifold Gasket for the left-hand cylinder bank, sealing the inlet manifold to the cylinder head. Seals the joint between the inlet manifold...

Radiator Hose connecting the radiator to the engine coolant vent elbow (degas / deaeration line) in the cooling circuit. Routes coolant between th...

Coolant Hose carries engine coolant through the cooling circuit, connecting the components that circulate coolant to and from the engine. Moulded ...

CV Boot Kit for the rear drive shaft constant velocity joint, providing the components required to renew the protective boot. The CV joint boot re...

Fuel Pump Support Housing Seal seals the mounting interface of the high-pressure fuel pump support housing on 2.0L Si4 petrol engines. The high-pr...

Front Wiper Blade - the driver's-side front windscreen wiper blade. Fits the driver's-side (right-hand-drive) front wiper arm.

Fuel Injector Pipe Clamp for the high-pressure fuel injection system of the 3.0L V6 and 4.4L V8 (SDV8) diesel engines. The clamp secures a high-pr...

Turbocharger Oil Return Hose Gasket for the 2.0L Si4 TIVCT petrol turbo engine. It seals the joint at the turbocharger oil return (drain) hose, al...

Body Moulding Retainer Clip, a lantern-type fastener for the vehicle's exterior trim. The clip secures exterior body mouldings - such as the rocke...

Oil Cooler Tube carries engine oil through the oil cooler circuit. The tube connects the engine oil system to the oil cooler, routing oil to be co...

O-ring for the variable valve timing (VVT) solenoid, part of the timing gear assembly at the front of the engine. The solenoid meters oil flow to ...

Rear Brake Disc - a vented disc from the rear brake disc and caliper assembly. The disc is mounted on the rear hub behind the road wheel and rotat...

Inlet Manifold Gasket for the left-hand cylinder bank of the 5.0 litre V8 petrol engine (AJ133). It seals the joint between the inlet manifold and ...

Vacuum Pump Seal - sealing ring between the engine-driven vacuum pump and its mounting face on the engine, forming part of the brake servo vacuum c...

Oil Separator is the crankcase ventilation (PCV) oil separator for the 2.0L 16V turbocharged petrol engine. It sits in the crankcase breather circ...

Crankcase Breather Pipe for the 3.0L V6 diesel, part of the crankcase ventilation circuit within the engine emission control system. The pipe conn...

Connector

O-Ring - Radiator Hose

Intercooler to Inlet Manifold Gasket from the charge air induction system of the supercharged 5.0L V8 petrol engine (AJ133). The supercharger and ...

Tailgate Latch is the closure latch of the tailgate / luggage compartment lock controls. It engages the body-mounted striker to hold the tailgate ...

Crankcase Ventilation Tube for the 3.0L V6 diesel, part of the crankcase ventilation circuit and located at the oil pan. The tube forms the sectio...

Gasket - Oil Cooler seals the engine oil cooler to its mounting face, within the Oil Cooler and Filter assembly. It maintains the integrity of the...

Mirror Housing Cover for the left-hand exterior door mirror, the outer cap that fits over the mirror housing. Supplied primed and requires paintin...

Turbocharger Water Inlet Gasket seals the coolant inlet connection at the turbocharger. It fits between the coolant feed union and the turbocharger...

Water Outlet Connection - coolant outlet component in the engine cooling circuit of the 3.0L DOHC GDI supercharged V6 petrol engine. It forms the ...

Idler Pulley for the front-end accessory drive of the 4.4L V8 diesel engine. The idler pulley provides a smooth rolling surface that routes and gu...

Heater Manifold - the rigid coolant tube that carries engine coolant from the engine block to the heater inlet hose, forming part of the cabin heat...

Steering Gear Connecting Rod is a steering linkage rod connecting the steering gear to the wheel-end steering arm. It transfers steering movement ...

Coolant Bleed Hose for the engine cooling system of the 4.4L V8 turbo-diesel (TDV8) engine. The hose forms part of the cooling-system bleed circui...

Front Brake Caliper Attachment Kit - the caliper fitting hardware for the front disc brake assembly. The kit contains the brake pad clips and the ...

Sealing Washer for the 4.4L DOHC DITC V8 diesel (TDV8). Seals a connection at the right-hand (primary) turbocharger. Renew on reassembly to ensure...

EGR Cooler Gasket for the exhaust gas recirculation (EGR) circuit of the 4.4L DOHC V8 turbo-diesel (TDV8) engine. The gasket seals the joint betwe...