Terrafirma Suspension Parts

Return to Centre Steering Damper for installation within the steering linkage assembly. This unit mounts between the axle steering arms and the st...

Steering Rod Kit for the steering linkage assembly, supplied with four greaseable track rod ends and a steering damper bracket. Replaces the origi...

Rear Shock Absorber provides damping control within the rear axle spring and damper assembly for suspension set up with extended travel. Twin-tube...

Front Cat-Delete Down Pipe replaces the catalytic converter section of the front exhaust on the Defender 2.4L TDCi (Puma). Manufactured from 1.5mm...

Anti-Roll Bar Bush in polyurethane, 28mm bore, for the rear anti-roll bar mounting. The bush sits where the bar is clamped to its chassis brackets...

Steering Damper mounts in the front steering linkage to absorb kickback and reduce shimmy transmitted from the front axle to the steering wheel. T...

Steering Guard - 8mm Alloy - LHD for underbody protection of the steering linkage assembly. Constructed from 8mm laser-cut alloy plate with a tape...

Rear Coil Spring Pair - Medium Load, +2" Lift (Terrafirma). These rear coil springs raise ride height by approximately 2 inches over standard and ...

Front Door Card is the interior trim panel that covers the inner structure of the front door, concealing the window regulator, latch linkage and wi...

Anti-Roll Bar for the rear suspension, 28mm bar diameter. The bar mounts to the chassis on a pair of clamped bushes and connects to the axle throu...

Turret Securing Rings - Front are reinforcement rings that fit around the front shock absorber top mount aperture in the inner wing. They distribut...

Rear Shock Absorber damps the rear suspension, controlling spring oscillation and wheel movement so the tyre stays in contact with the road and the...

Intercooler Hose Kit replaces the standard rubber hoses in the intercooler circuit of the Defender 2.4L TDCi (Puma) engine. This kit includes the ...

Shock Absorber Bush Kit for the mounting points of Terrafirma TS-series shock absorbers. The kit provides the hardware required to replace worn bu...

Bonnet Chequer Plate in black for the Land Rover Defender (2007-2016, Puma). This 3mm aluminium chequer plate fits the restyled Puma-era bonnet an...

Air-to-Coil Conversion Kit - +2" lift, medium load, with standard-travel All Terrain shock absorbers - for Discovery 2. Converts the Discovery 2 r...

Front Shock Absorber provides damping control on the front axle for suspension raised by approximately 50 mm. Twin-tube big-bore construction with...

Centre Silencer Replacement Pipe occupies the centre section of the exhaust system, replacing the original centre silencer with a free-flowing stra...

Shock Absorber - Front - +2" Travel for the front coil spring suspension system, designed for use with a 2-inch suspension lift. The extended-trav...

Polyurethane Suspension Bush Kit A complete polyurethane bush set that replaces the original rubber suspension bushes across the chassis-mounted su...

A-Frame Ball Joint Bracket forms the pivot connection at the apex of the rear axle A-frame linkage. It mounts to the rear axle housing and locates ...

Radius Arm Bush Kit - Chassis End, Front (Terrafirma). A set of four uprated polyurethane bushes for the front radius arm mountings, replacing the...

Rear Crossmember Recovery Point - a bolt-on recovery attachment that mounts centrally to the rear chassis crossmember, providing a heavy-duty lashi...

Front Spring Spacers fit between the front axle and the base of the front coil spring to raise the spring mounting point. The spacers are 50mm (2 ...

Winch Remote Control - Plug-In

Steering Rod Set for the front steering linkage, comprising the track rod and drag link that transmit steering movement from the steering box acros...

Extended Anti-Roll Bar Link for the left-hand side of the suspension, designed for use on vehicles with 2 to 3 inches of suspension lift. The stan...

Modular Steel Wheel is a heavy-duty 8-hole steel road wheel finished in satin black. Specification: 18 x 8 inch, ET45 offset, 5 x 120 PCD, rated t...

Absorber Shock

Watts Linkage Complete Bush Kit renews the polyurethane bushes throughout the rear Watts linkage, the lateral location mechanism that controls side...

Silicone Turbo & Intercooler Hose Kit - a three-piece set of silicone charge-air hoses for the 300Tdi turbo and intercooler circuit, replacing ...

Sport Front Grille & Headlamp Surround Kit - a front-end exterior styling set that replaces the factory front grille and headlamp surrounds. I...

Shock Absorber for the rear suspension, controlling axle movement and damping spring oscillation between the axle and the chassis mounting points. ...

Steering Damper - 4-Stage Adjustable for Land Rover Defender 90, 110, and 130. This hydraulic steering damper mounts between the axle and chassis ...

Anti-Roll Bar Bush for the front suspension system, sold as a pair. This bush locates the anti-roll bar at its chassis mounting points, allowing t...

Raised Air Intake relocating the engine air intake to an elevated position at the A-pillar, drawing clean air from above the standard bonnet-level ...

Roof Centre Console for the Defender Hard Top and Station Wagon interior headlining. The console features a single DIN radio aperture with removab...

Anti-Roll Bar Spacer Kit for the anti-roll bar mounting assembly on the Defender. Designed for use with 4-hole mounting brackets, these spacers en...

Suspension Kit providing 2 inches of lift in a medium load configuration, combining rated coil springs with All Terrain shock absorbers. Designed ...

Front Coil Spring - Medium Load for the Discovery 2 front suspension assembly. The spring mounts between the front axle spring pan and the chassis...

Terrafirma Pro Sport Suspension Kit - Medium Load, +2" (50mm) Lift for Defender 110 and 130. This is a RAISED suspension kit: it lifts the vehicle...

Anti-Roll Bar Fitting Kit - the rear mounting hardware used to install an uprated rear anti-roll bar in the rear suspension. The uprated bar is wi...

Suspension Bush - Rear Lower, polyurethane, supplied as a set of two bushes with internal sleeves and installation grease for the axle-end mounting...

Front Spring Spacers fit between the front axle and the base of the front coil spring to raise the spring mounting point. The spacers are 50mm (2 ...

Electronic Differential Lock (E-Locker) replaces the standard open differential assembly within the axle, providing driver-selectable full differen...

Shock Absorber - rear suspension damper with four-stage adjustable damping, for standard ride-height travel. Fitted between the chassis and rear a...

Height Sensor Lift Rod Kit for air suspension systems on the Discovery 3, Discovery 4 and Range Rover Sport. The air suspension height sensors use...

Big Bore Expedition Shock Absorber - front position, standard ride height. The damper installs between the front axle mounting and the chassis bra...