Land Rover Parts

Windscreen Pillar Moulding - the exterior A-pillar finisher that covers the left-hand windscreen pillar. This outer moulding fits over the front p...

A-Post Trim Finisher - Left Hand - the near-side exterior trim that caps the windscreen A-pillar, running down the side of the windscreen aperture....

A-Post Finisher - Outer (Right Hand) - the off-side outer exterior trim that caps the windscreen A-pillar, running down the side of the windscreen ...

Finisher

A-Pillar Trim Strip is an exterior body finisher fitted along the A-pillar, covering the joint between the pillar and the roof panel. Supplied in ...

Land Rover Oval Name Badge - Plastic - exterior identification emblem carrying the Land Rover name in gold lettering on a green ground, moulded in ...

LED Clear Side Repeater (Pair)

Service Kit Inc Cataclean - Defender & Discovery 2 TD5

Air Spring Lift Kit - +50mm - a pair of extended air springs (airbags) that raise the rear ride height by 50mm while retaining the self-levelling a...

Injector Seal Kit for the Td5 2.5-litre five-cylinder turbo diesel, renewing the sealing components at all five injectors. The kit contains five c...

Injector Seal Kit for the Td5 2.5-litre five-cylinder turbo diesel, renewing the sealing components at all five injectors. The kit contains five c...

Clutch Kit - the friction-clutch assembly for the Td5 2.5L five-cylinder turbo diesel, supplied without the release bearing. The kit comprises the...

Cylinder Head Gasket Set for the Td5 2.5L 5-cylinder turbo diesel, supplying the ancillary seals and gaskets used around the cylinder head when it ...

Door Handle Gasket for the rear door. The gasket seals the rear door handle and lock cover against the door skin, preventing water ingress into th...

Front Door Glass Guide is a moulded plastic guide that locates the front door drop glass within its window channel. Fitted inside the door frame, ...

Exterior Door Mirror Glass - left-hand, flat - for the door mirror assembly. The replaceable flat glass fits the left-hand exterior mirror housing...

Hose Clip is a worm-drive band clamp used to secure flexible rubber hoses onto rigid pipe spigots and unions across the coolant, heater, fuel and i...

Lower Engine Gasket Set for the Td5 2.5L five-cylinder turbo diesel engine. Contains the gaskets used when working on the lower half of the engine...

Mud Flap Bracket is the right-hand rear mudflap retention bracket - the stay that mounts the rear mud flap to the body and holds it in position beh...

Mud Flap Bracket - front mud flap retention bracket. Forms part of the front mud flap assembly, securing the flap to its underbody and wheel-arch ...

Mud Flaps shield the bodywork and following traffic from the road spray, mud and stones thrown up by the wheels. Supplied as the right-hand pair f...

Fuel Filler Latch Clip is a small retaining clip within the fuel filler flap assembly. It holds the spring-loaded latch in position inside the fil...

Firtree Clip - a push-in fastener with a ribbed, fir-tree profile that grips into a pre-drilled panel hole. Used to secure trim panels, wiring loo...

Bumper Mounting Bobbin is a mounting bobbin for the front bumper. It sits between the bumper and its mounting bracket, locating the front bumper a...

Roof Drip Rail Finisher is an exterior moulding that caps the roof drip rail. It runs along the roof-to-body joint, covering the drip channel to g...

Gaiter Bezel - Gear Lever - the trim surround that frames the gear lever gaiter where it meets the centre console, forming part of the console trim...

Nyloc Nut - M16 flanged self-locking nut used at suspension link fastenings. The integral flange spreads the clamp load across the joint face and ...

Flanged Bolt secures the steering damper bush at the steering damper mounting. The flange spreads the clamp load across the bush, retaining the da...

Washer Non-Return Valve for the windscreen wash/wipe system. The valve is fitted into the washer fluid line between the pump and the jets. It perm...

Front Fog Lamp is the right-hand front fog lamp assembly within the exterior front lighting system. Mounted in the right-hand side of the front bu...

Wiper Spindle Washer for the rear screen wiper assembly. This plastic outer washer fits over the wiper spindle where it exits the body panel, seati...

Wiper Motor Grommet for the rear screen wiper assembly. It seals the aperture in the rear door or tailgate where the wiper motor spindle passes thr...

Underside Protection Bar - a front underbody protection member for the body and chassis. Mounted transversely across the chassis at the front end,...

Clutch Driven Plate - the friction disc of the clutch, splined to the gearbox input shaft and clamped between the flywheel and the clutch cover. I...

Clutch Plate

H3 Halogen Bulb, 55W, single-filament. The H3 is a single-filament halogen capsule with a flying-lead connector, used in auxiliary lighting units ...

Rocker Shaft Spring for the Rover V8 valvetrain, fitted on the rocker shaft assembly. The spring acts as a spacer between adjacent rocker arms, ho...

LED Festoon Bulb for interior lamps. A double-ended festoon LED that replaces the standard filament festoon bulb in the courtesy, map and interior...

Grommet fits the bonnet release and locking mechanism. It lines the panel aperture through which the bonnet release cable passes, sealing the open...