Products

Gear Lever Gaiter, Inner. Flexible boot in the gear lever and transmission tunnel assembly. It seals the aperture where the main gearbox lever pas...

Auto Selector Guide Box is the guide housing for the automatic transmission gear selector lever. It mounts the selector mechanism and guides the l...

Door Trim Clip for the interior door casing assembly. Fir-tree fastener that secures the door trim casing to the door frame, locating it in the pa...

The Interior Door Card Snap Sac Trim Clips are designed to securely fasten your vehicle's door card and trim pieces. Fitment: all models

Snap-sac trim clip - the push-in plastic fastener that secures interior trim panels to their supporting structure. The clip passes through a hole ...

Wheelarch Panel is the inner skin of the right-hand rear wheel arch, fitted in the rear load area of the Discovery 1 5-door. The steel pressing fo...

Wheelarch is the inner skin of the left-hand rear wheel arch, fitted in the rear load area of the Discovery 1 5-door. The steel pressing forms the...

Bonnet Striker is part of the bonnet latch mechanism — the striker that the bonnet catch engages to hold the bonnet closed. When the bonnet is shu...

Bonnet Assembly is the hinged body panel that closes over the engine bay. The assembly consists of the outer bonnet skin and its inner reinforceme...

Front Wing is the outer body panel that encloses the left-hand front wheel arch. It forms the side of the engine bay and the front wheel arch, run...

Rear Door Glass for the right-hand rear door. This is the main window pane that raises and lowers within the door. It is guided by the glass run c...

Rear Side Door Glass for the left-hand rear side door. This is the main window pane that raises and lowers within the door. It is guided by the gl...

Roof Gasket seals the joint between the roof panel and the body structure on the Discovery 1. The gasket runs around the roof panel perimeter, pre...

Inner Sill - RH is the structural steel inner sill section on the right-hand side of the Discovery 1. The inner sill forms the lower edge of the d...

Inner Sill - LH is a structural body repair panel in the lower body assembly of the Discovery 1. The inner sill runs along the base of the door ap...

Door Casing Stud for the interior door casing assembly. Locating stud onto which the door casing mounts, retaining the trim panel and holding it i...

Door Casing Stud - plastic push-fit stud used to secure interior trim panels to the door frame and body structure. The stud passes through the tri...

Door Casing Stud for the interior door casing assembly. Locating stud onto which the door casing mounts, retaining the trim panel and holding it i...

Rear Door Lock Cover Gasket, the seal fitted behind the rear door handle and lock cover. It seats between the exterior handle/lock cover and the o...

Glass Run Channel - window run channel fitted to the front door frame, part of the front door glass and regulator assembly. The channel lines the ...

Fir Tree Fastener in light grey, for the roof trim and headlining assembly. Push-fit fastener that secures roof trim panels and headlining ancilla...

Fuel Tank Inspection Plate Seal is a rubber sealing gasket for the fuel tank inspection plate in the fuel tank assembly. The inspection plate prov...

Pipe and Hose Retaining Clip - Engine is a small-bore clip used to retain pipes and hoses at multiple points across the engine bay and fuel system ...

Rear End Door Latch is the latching mechanism for the rear end door, part of the door lock and latch assembly. It engages the striker mounted on t...

Front Door Hinge mounts the front door to the A-post (the front body pillar), forming part of the door hinge assembly. The hinge carries the full ...

Door Hinge mounts a side door to its body pillar, forming part of the door hinge assembly. The hinge carries the weight of the door and sets its a...

Rear Door Lock Cover Badge - badged cover fitted over the rear door lock aperture, part of the rear door exterior handle and lock assembly. The co...

Front Door Handle is the exterior handle assembly for the front door, part of the door lock and latch system. Operating the handle acts through th...

Fastener - black plastic drive-type (fir tree) push-in fastener used throughout the vehicle to secure body trim panels, interior linings, underbonn...

Exterior Door Handle Seal for the door locks and handles assembly. The seal sits between the outer door handle and the door skin, closing the gap ...

Rear Roof Rail Gasket for the roof side-rail mounting assembly. This gasket seats between the rear of the side roof rail and the roof panel, seali...