Land Rover Discovery 5 Parts

Anti-Roll Bar Bush for the front conventional stabiliser bar. This rubber insulator clamps the front anti-roll bar to its chassis mounting bracket...

Lower Inlet Manifold Gasket for the supercharged 3.0L V6 petrol engine. It seals the lower section of the inlet manifold to the cylinder head, seal...

Inlet Valve for the supercharged 3.0L V6 petrol engine (AJ126). The inlet valve seals against its seat in the cylinder head and opens on the intake...

Fuel Injector Refit Kit - the seals and retainer required when removing and refitting a fuel injector on 3.0L V6 and 5.0L V8 supercharged petrol en...

Bolt is a threaded fastener used within the chassis and suspension assemblies. It secures mounting points across suspension, stabilizer bar and re...

Accessory Drive Belt from the front-end accessory drive. The primary serpentine belt driven by the crankshaft pulley to turn the engine ancillarie...

Nut is a fastener used to secure suspension and mounting components at their attachment points. It is specified at several chassis locations, incl...

Bolt for the suspension mountings. Secures front and rear suspension arms, struts and springs at their attachment points under suspension loads.

O-Ring for the variable valve timing (VVT) solenoid. Seals the VVT solenoid where it locates into the cylinder head, retaining oil pressure to the...

Water Outlet Tube carries coolant between the water pump and the thermostat housing within the engine cooling circuit. For 3.0L supercharged V6 an...

Bolt - front brake caliper mounting bolt. The bolt secures the front brake caliper to the hub carrier, clamping the caliper against its mounting f...

Ride Height Sensor - rear electronic air suspension height sensor. The sensor links the rear suspension arm to the body and continuously reports t...

Ride Height Sensor - electronic air suspension height sensor. The sensor links the suspension arm to the body and continuously reports the ride he...

Rear Anti-Roll Bar Bush - locates the rear anti-roll bar (stabiliser bar) to the chassis. The bush clamps around the anti-roll bar where it mounts...

Sealing Ring seals the joint between the engine oil cooler and the water pump on the AJ133 5.0L V8 and 3.0L supercharged V6 petrol engines. It mai...

Sealing Ring seals the joint between the engine oil cooler and the water pump on the AJ133 5.0L V8 and 3.0L supercharged V6 petrol engines. It mai...

Oil Level Sensor - electronic engine oil level sensor mounted in the wall of the sump, forming part of the engine lubrication monitoring circuit. ...

Sealing ring kit for the engine oil cooler and oil filter housing connections on the 3.0L V6 diesel. The rings seal the oil transfer joints betwee...

Rear Brake Disc - a vented disc from the rear brake disc and caliper assembly. The disc is mounted on the rear hub behind the road wheel and rotat...

Oil Level Sensor - electronic engine oil level sensor mounted in the wall of the sump, forming part of the engine lubrication monitoring circuit. ...

Brake Hose for the rear left-hand corner of the braking hydraulic circuit, supplied complete with its mounting bracket. The flexible hose carries ...

Ride Height Sensor Link Rods - 1.5 in Lift. Replacement link rods for the air suspension ride height sensors. Each rod replaces the fixed-length f...

Glow Plug for the diesel cold-start pre-heating circuit. The plug threads into the cylinder head with its heating element projecting into the combu...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Timing Gear Bolt - Lower is the M16 x 70mm flanged hex bolt that retains the lower timing gear on the crankshaft. It is also listed as the cranksha...

O-Ring for the oil pump outlet tube, sealing the pressurised feed within the oil pump, sump and filter assembly. The outlet tube carries oil from ...

Fuel Pump O-Ring Seal, 31mm x 2mm - the sealing ring at the fuel pump / fuel injection pump joint. This O-ring is the only seal at that joint, so ...

Torque Converter Seal Kit - ZF 8-Speed

Glow Plug for the diesel cold-start pre-heating circuit. The plug threads into the cylinder head with its heating element projecting into the combu...

Exhaust Gas Temperature Sensor for the exhaust after-treatment system of the 3.0L V6 diesel engine, fitted at the centre (middle) position. It mon...

Cylinder Head Gasket seals the joint between the cylinder head and the engine block on the 3.0L V6 turbo diesel engine, containing combustion press...

Diverter Solenoid Valve is the turbocharger compressed-air recirculation (diverter) valve in the boost-control circuit. On throttle lift-off it re...

Oil Seal for the oil level sensor where it passes through the wall of the oil pan (sump). The sensor is retained in the sump and this ring forms t...

Front Brake Disc with a corrosion-protective coating, for the front axle braking system. The disc forms the friction surface that the front brake ...

Plastic Rivet is a push-fit fastener that secures front engine-compartment insulation panels to the body. It locates into a pre-formed panel hole t...

Cylinder Head Bolt secures the cylinder head to the engine block on V6 and V8 petrol engines. Threaded M11 x 178 mm. Twenty bolts are required per...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...