Genuine Land Rover Parts

Insulator - Stabilizer Bar

Body Moulding Retainer Clip, a lantern-type fastener for the vehicle's exterior trim. The clip secures exterior body mouldings - such as the rocke...

Accessory Drive Idler Pulley - Lower in the front end accessory drive (FEAD) belt system of the 2.0L 16V turbocharged petrol engine. The lower idl...

Accessory Drive Idler Pulley in the front end accessory drive (FEAD) belt system of the 2.0L 16V turbocharged petrol engine. The idler pulley guid...

Bracket - Bumper Mounting

Bracket - Bumper Mounting

Lamp - Side Flasher

Lamp - Side Flasher

Trim Clip - a plastic push-fit retaining clip used to secure exterior trim and body mouldings to the vehicle. It locates in a pre-drilled panel hol...

Thermostat and Housing assembly for the 2.0L 16V TIVCT turbocharged petrol (GTDi) engine. The thermostat regulates coolant flow to bring the engine...

Rear Brake Disc, solid type, 302mm diameter, forming part of the rear axle braking assembly. The disc provides the friction surface for the rear b...

Plastic Rivet is a push-fit fastener that secures front engine-compartment insulation panels to the body. It locates into a pre-formed panel hole t...

Seal - Door Front and Rear

Fuel Sender Cover for the fuel tank sender unit. It fits over the sender module aperture in the fuel tank, enclosing the fuel level sender assembly...

Exhaust Manifold Gasket seals the joint between the turbocharger and the exhaust manifold, containing exhaust gas at the flanged connection. Fitte...

Exhaust Manifold Gasket seals the joint between the turbocharger/exhaust manifold and the cylinder head, containing exhaust gas at the port face. ...

Strap - Fuel Tank

Windscreen Washer Reservoir stores the washer fluid supply for the screen wash system and, on this variant, the headlamp power wash jets. This res...

Valve Cover Gasket seals the joint between the camshaft cover and the cylinder head on the 2.0L 16V turbocharged petrol engine. It forms the oil-t...

Oil Separator is the crankcase ventilation (PCV) oil separator for the 2.0L 16V turbocharged petrol engine. It sits in the crankcase breather circ...

Turbocharger Water Inlet Gasket seals the coolant inlet connection at the turbocharger. It fits between the coolant feed union and the turbocharger...

Lower Rear Knuckle Bush locates the rear suspension knuckle to its lower suspension arm. Flexible mounting bush fitted at the lower link of the re...

Parcel Shelf Strap Button is the pivot fixing that anchors the parcel shelf support strap in the load compartment. The support strap lifts the par...

Bonnet Gas Strut supports the bonnet in the raised position and dampens its opening and closing. Gas-pressurised lift strut mounted between the bo...

Camshaft Sprocket Washer for the 2.0L 16V TiVCT turbocharged petrol engine (Si4 240PS and Gen2). It fits at the camshaft sprocket within the timing...

Exhaust Pipe Gasket for the front exhaust section of the 2.0L turbocharged petrol engine. Seals the flanged front pipe to catalyst joint, providin...

Air Intake Duct for the 2.0L Si4 turbocharged petrol engine. It channels intake air through the induction system on its way to the turbocharger and...

Oil Drain Plug for the 2.0L 16V petrol engine. It seals the drain point in the oil pan (sump) and is removed to drain the engine oil at a service.

Timing Gear Bolt for the 2.0L 16V petrol engine. It secures a gear on the engine's timing drive.

Valve Spring Retainer for the 2.0L 16-valve turbocharged petrol engine, fitted in the cylinder head valve train. The retainer caps the top of the ...

Crankshaft Damper Washer for the 2.0L 16-valve turbocharged petrol engine, fitted in the crankshaft damper assembly at the front of the timing gear...

Accessory Drive Pulley Bolt for the 2.0L 16-valve turbocharged petrol engine, used in the accessory drive belt system. The bolt secures the access...

Oil Filter Adaptor Gasket for the 2.0L 16-valve turbocharged petrol engine, sealing the oil cooler and filter adaptor to the engine. The gasket fo...

Timing Chain Guide for the 2.0L 16-valve turbocharged petrol engine, fitted in the timing gear assembly at the front of the engine. The guide loca...

Cylinder Head Gasket for the 2.0L 16V TiVCT turbocharged petrol engine, sealing the joint between the cylinder head and the engine block. It conta...

Auxiliary Battery - a sealed, non-spillable wet-cell battery that serves as the vehicle's secondary power source, separate from the main starter ba...

Engine Mounting Bolt with hexagonal head, M12 x 112 mm. A structural fastener securing the engine mounting to the subframe; the same bolt is also ...

Engine Mounting supports the engine on the subframe and damps vibration transmitted into the body. Fitted to the 2.0L 16V TiVCT turbocharged petro...

Tube - Outlet