Genuine Land Rover Parts

Injector O-Ring for the 2.5L Td5 5-Cylinder Turbo Diesel fuel injection system. This O-ring seats in the groove on the injector body at the cylind...

Injector Sealing Washer seals the base of the fuel injector into the cylinder head on the Td5 2.5L 5-cylinder turbo diesel engine. The washer sits...

Choke Clip is the retaining clip that secures the choke cable at the Zenith carburettor. Part of the choke cable installation, it anchors the oute...

Pipe seal

EDC switch Puma

Fuel Filler Cap - the cap that closes and seals the fuel tank filler neck. It screws onto the filler neck to seal the fuel system, retaining fuel ...

Fuel Pipe Olive for the fuel supply line. The olive is the compression ferrule that seats between the fuel pipe and its union fitting. When the un...

Fuel Filter for the diesel fuel supply system of the 2.2L DW12 common-rail direct-injection turbo diesel engine. It is fitted in the fuel line betw...

Fuel Tank Adaptor Ring secures the in-tank fuel pump and sender unit assembly into the aperture on the top of the fuel tank. The ring locks the pu...

Carburettor Repair Kit for the six-cylinder petrol engine carburettor. It supplies the renewable service parts used to overhaul the carburettor and...

Military fuel cap

Spring Washer is an M8 double-coil spring washer used as a fastening component in body and chassis assemblies. The double-coil spring form maintai...

Coolant Hose connecting the radiator to the fuel cooler within the engine cooling circuit. It routes engine coolant to the coolant-cooled fuel coo...

Fuel Tank Vent Hose - part of the fuel tank ventilation circuit on Puma TDCi models. It carries fuel vapour from the tank, allowing the tank to br...

Pump Injection Ring

Fuel Injector Bolt - retaining bolt securing the fuel injector clamp to the cylinder head on the 2.4L Duratorq TDCi (Puma) common-rail diesel engin...

Fuel Filler Grommet seals the joint between the fuel tank filler neck and the body aperture, within the fuel filler assembly. The rubber grommet l...

P-Clip - 19/64" x 3/8" is a pressed-steel P-profile retaining clip used to route and secure fuel lines, brake pipes, or wiring looms against a chas...

Accelerator Rod in the throttle linkage. This rigid rod transmits accelerator pedal movement through the linkage to operate the engine throttle.

Accelerator Cable for the VM Diesel engine, left-hand-drive (LHD) configuration. Connects the accelerator pedal to the injection pump as part of th...

Carburettor Overhaul Kit for the 2.25L four-cylinder petrol engine. The kit renews the perishable sealing and metering components of the carburetto...

Primary Fuel Filter for the diesel fuel supply system of the 2.0L I4 diesel (AJ200 / AJ20D4 / AJ21D4) engine. The primary filter separates water a...

Hose - Filler Pipe

Strap - Fuel Tank

Throttle Seal for the intake throttle valve housing. It fits at the joint between the throttle body and the intake, maintaining an airtight connec...

Throttle Body Housing Seal seals the rear interface of the throttle body housing where it mates with the adjoining intake ducting, within the engin...

Fuel Tank Vent Hose - part of the fuel tank ventilation circuit, allowing the tank to breathe and equalise internal pressure as fuel level and temp...

Fuel Filter within the diesel fuel supply assembly. This filter traps particulate contamination in the fuel supply circuit before fuel reaches the...

Fuel Filter TD4

Filler Pipe Securing Ring for the fuel filler pipe assembly. This retaining ring secures the fuel filler pipe to the fuel tank inlet, maintaining ...

O-Ring for the fuel injector harness assembly on the Td5 2.5L 5-Cylinder Turbo Diesel engine. This O-ring provides a seal within the fuel injector...

Fuel Filler Seal - sealing ring fitted at the fuel filler, part of the fuel tank filler assembly. Seals the joint at the filler neck to prevent fu...

Fuel Filter for the TD4 2.0L diesel engine fuel system. This filter element installs within the fuel filter housing in the engine bay fuel circuit...

Accelerator Cable for the Range Rover Classic 3.5L V8 carburettor engine, left-hand drive, manual transmission. This cable connects the accelerato...

Fuel Pipe for the 200 TDi diesel fuel delivery circuit. Connects the fuel filter outlet to the injection pump inlet, carrying filtered fuel to the...

Fuel Tank Bracket for the fuel tank mounting assembly on the Defender. This steel bracket secures the fuel tank to the chassis, forming part of th...

Injector Spill Pipe links the fuel injectors in the 2.5L 4-cylinder turbo diesel injection system. It returns leak-off (spill) fuel from the injec...

rod control GENUINE LR - 2.25 petrol and 2.6 petrol, 1968 onwards

Washer - Diesel Sedimentor is a sealing washer used in the diesel fuel sedimentor (fuel filter/water separator) assembly on diesel-engined Land Rov...

Fuel Tank Mounting Washer is used at the fuel tank mounting points, spreading the clamping load of the fixing across the mounting bracket or strap....

Washer

Diesel Fuel Filter Plug Seal - a sealing ring for the drain plug on the diesel fuel filter and sedimentor. It seals the drain/bleed plug against t...

Accelerator Cable for the throttle control linkage, connecting the accelerator pedal to the engine's throttle mechanism. The cable transmits pedal...

Injector Bush for the VM 2.4L and 2.5L 4-cylinder turbo diesel engine in the Range Rover Classic. This bush is fitted at the cylinder head to loca...

Strap fuel tank Defender 110 TD5/TD4

Leak-Off Tube - Injection Pump

Fuel Pump Assembly Complete fuel pump unit in the fuel delivery system, drawing fuel from the tank and supplying it to the engine under pressure. ...