Genuine Land Rover Parts

pipe clip 1/2" (12.7mm) for 3/8" (9.5mm) hole

Differential Shim - 0.072in, for the Rover-type differential. Fitted during differential setup to set bearing preload and gear alignment. Shim thi...

Hose Clip Spring is the spring connector clip for the heater demister and air outlet pipes. Retains the demister ducting and outlet flaps within t...

Inlet Air Seal for the Solex carburettor connection on the 2.25L 4-cylinder petrol induction system. Seals the joint between the air intake and th...

Fuel Return Tube for the 2.7L TDV6 diesel engine. This tube forms part of the fuel return circuit, routing excess fuel from the injectors or fuel ...

Plastic Clip is a retainer clip for the front windscreen lower finisher trim. It secures the lower plastic finisher panel to the windscreen surround.

Outer Door Handle is the external grab handle for the right-hand door, part of the door latch mechanism group. Mounted on the outer door skin, the...

Door Lock Cover Plate Seal for the rear-end door latch assembly. The gasket seals the lock cover plate against the door, keeping water and dust ou...

Pipe

Housing Gasket

Defender 110 Decal - black, approximately 26cm length. Self-adhesive black Defender 110 model identification decal from the Defender transfers and...

Radio Receiver Kit is the radio-frequency receiver for the remote central locking and alarm system, operating on the 315 MHz band. Mounted within ...

Front Side Lamp forms part of the exterior lighting system, providing front position and side marker illumination. Mounted at the front of the veh...

Cigar Lighter is the knob and heating-element assembly that fits the cigar lighter socket on the centre console. The knob houses a coil heating el...

Console Switch Bezel Ring is the trim surround for the floor switch assembly on the centre console. It frames the console switch panel, locating a...

ECU - One-Touch Rear Fog Lamp is the control module for the one-touch rear fog lamp function in the exterior lighting circuit. The unit takes a mo...

Cover remote control GENUINE LR PAD ONLY!

Relay Black 2A 4 Pin

Cruise Control Switch mounted on the steering wheel, part of the cruise control operating circuit. The switch carries the set, resume and cancel f...

Heated Seat Switch for the left-hand seat, part of the interior seat-heating control circuit. The switch uses a push-push (latching) action and mo...

Hill Descent Control Switch is the facia-mounted switch that engages the Hill Descent Control (HDC) system. When activated at low speed, HDC uses ...

Rear Wash/Wipe Switch is the momentary control mounted in the instrument binnacle for the rear screen wash and wipe function. Pressing the switch ...

Washer Switch Assembly mounted in the instrument panel facia, this push-type switch activates the windscreen washer pump circuit, supplying washer ...

Front Bumper Wiring Harness, part of the body and bumper electrical loom. This harness routes through the front bumper and supplies both the front...

Alternator Assembly - Freelander TD4

Parking Aid Sensor - ultrasonic transducer for the Parking Distance Control (PDC) system, mounted through the rear bumper cover. Straight-bodied ty...

Aid Parking Sensor