Range Rover Evoque L551 Parts

Cylinder Head Bolt with hex head, for the 2.0L I4 diesel (AJ200) engine. The bolt secures the cylinder head to the engine block, providing the cla...

Shock Absorber Boot for the suspension damper assembly. The boot sheaths the exposed damper piston rod, shielding it from grit, moisture and road ...

Turbocharger Gasket for the exhaust turbocharger assembly on the 2.0L I4 diesel (AJ200) engine, sealing the turbocharger outlet to the exhaust fron...

Element - Air Cleaner

Wheel Centre Cap for the alloy road wheel. This cover fits to the hub centre of the alloy wheel, closing off the centre bore and completing the wh...

Transmission Fluid is the specified fluid for the electronically controlled all-wheel-drive coupling (Haldex-type) used on transverse-engine models...

Metal Name Plate is an exterior badge fitted to the bodywork. It mounts to the body panel as a model or trim identifier and forms part of the vehic...

Brake Fluid for the hydraulic braking and clutch actuation system, supplied in a 1 litre container. A DOT 4 low-viscosity (ESL) fluid formulated f...

Power Transfer Unit Seal is an oil seal for the Power Transfer Unit (PTU) on transverse all-wheel-drive models. The PTU takes drive from the trans...

Kit - Gear Shift Trigger

Automatic Transmission Fluid (ATF) for the automatic gearbox and power steering circuit. Specified as the transmission and power steering fluid to...

Oil - Differential

Drive Chain Idler - timing gear idler sprocket for the 2.0L four-cylinder Ingenium engine family (AJ200 / AJ20 series, petrol and diesel). The idl...

Wheel Cover set, fitted over the road wheels. The covers clip over the wheels to give a finished appearance and shield the wheel face from road di...

Wheel Cover for the road wheel. The cover fits over the wheel to give a finished appearance and shield the wheel face from road dirt and brake dus...

Diesel Exhaust Fluid (AdBlue) for diesel vehicles fitted with a selective catalytic reduction (SCR) exhaust after-treatment system. The fluid is h...

Idler Pulley for the accessory drive belt system, mounted on the front of the engine within the auxiliary belt run. The idler pulley drives nothin...

Front Crankshaft Oil Seal - radial lip seal in the cylinder block and front cover assembly, sealing the crankshaft nose where it passes through the...

Axle Oil 75W-90 is a hypoid gear oil for the front and rear differentials and final drive units. The 75W-90 grade lubricates the crown wheel and p...

Flanged Nut with an integral flange that spreads the clamping load and helps resist loosening, removing the need for a separate washer. Used to se...

Retaining Clip is a fastening clip used in the radiator grille and front bumper assembly. It secures the grille and front bumper trim components t...

Clip - retaining clip for the radiator grille and front bumper assembly. It secures the grille and bumper components to their mountings.

Cylinder Head Gasket sealing the cylinder head to the engine block. Fitted to the 2.0L four-cylinder AJ200 (Ingenium) petrol engine, including PHE...

Fuel Filler Restrictor for diesel vehicles, fitted inside the fuel filler neck as part of the fuel tank and filler assembly. It forms a physical b...

Brake Pads for the rear axle, part of the rear brake discs and calipers assembly. The pads are clamped by the caliper pistons against both faces o...

Sealing Ring - the right-hand outer seal for the front axle case, part of the front driveline. It seals the point where the front driveshaft passe...

Trim Clip that secures interior and exterior trim panels, door finishers and mouldings to the body. The clip locates in a pre-formed panel apertur...

Timing Chain - Secondary, Upper is part of the camshaft drive of the 2.0L Ingenium four-cylinder turbo diesel (AJ200D / AJ20D4). It runs in the up...

Fuel Pressure and Temperature Sensor for petrol fuel-injection systems. The combined sensor measures fuel rail pressure and fuel temperature and r...

Timing Chain for the timing drive of the 2.0L Ingenium four-cylinder diesel engine (AJ200D / AJ20D4). This is the lower, primary chain of the two-...

Bumper Retainer Nut - a push-in retaining nut used in the front bumper, radiator grille and rear bumper assemblies. The retainer clips into a pres...

Glow Plug Control Unit - the switching and control module of the diesel pre-heat system, wired between the battery supply and the glow plugs. The ...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Radiator Cap - screw-on pressure cap for the coolant expansion tank in the engine cooling system. The cap seals the expansion tank and holds the c...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

Wheel hub bearing for the front and rear knuckle and hub assemblies. The bearing carries vehicle load between the hub and the knuckle and allows t...

Solenoid Switch for the centre console switch pack, serving as the engine start-stop control. Mounted in the console and facia switchgear, it sign...

Axle Case Seal - Front seals the front axle case (final drive housing) around the driveshaft where it passes through the case. It retains the diff...

Driveshaft Retainer Circlip locks the inner end of the front driveshaft into the differential inside the front axle case. The clip springs into a ...

Driveshaft Oil Seal - Inner - Front RH is fitted to the front axle case (final drive housing) and seals around the inner end of the right-hand fron...