Range Rover Parts

Cylinder Head Bolt - a 7/16" UNC x 2-1/4" short-type bolt for the Rover V8, part of the cylinder head fixings. This is the shorter of the head bol...

Grommet - Safety Harness Anchorage

Thrust Sleeve fits over the front axle half shaft within the constant velocity (CV) joint and swivel housing assembly. It locates between the CV j...

Seal Washer - Swivel Pin Housing is the joint washer that seals the lower swivel pin mounting within the front axle swivel pin housing assembly. C...

Swivel Pin Housing Shim used to set the swivel pin bearing preload on the front axle swivel assembly. The shim is fitted at the swivel pin to adju...

Swivel Pin Housing Shim - 0.005in is a 0.005 in (0.13 mm) shim used to set the bearing preload in the front axle swivel pin housing assembly. Fitt...

Swivel Pin Housing Shim (0.003in) used to set the swivel pin bearing preload on the front axle swivel assembly. The shim is fitted at the swivel p...

Flywheel Ring Gear (starter ring gear) for the diesel flywheel, part of the clutch and flywheel assembly. The toothed ring is fitted around the fl...

Crankshaft Thrust Washer - 0.010in oversize, supplied as a pair. Fitted at the centre main bearing of the four-cylinder engine to control cranksha...

Mudflap Bracket - Front - LH secures the front mudflap to the body on the left-hand side of the vehicle. Part of the front mudflap assembly, the b...

Mudflap Bracket for the front, right-hand side. This bracket secures the front mudflap to the body, holding it at the correct position behind the ...

Front Wing Mounting Rail for the left-hand side. This rail forms the upper mounting line for the front wing, providing the fixing points along whi...

Front Wing Mounting Rail for the right-hand side. This rail forms the upper mounting line for the front wing, providing the fixing points along wh...

Halogen Bulb - H4 100/80W (Non-CE). Dual-filament headlight bulb rated 100W high beam and 80W low beam, providing increased light output over the s...

Front Wiper Blade for the windscreen wiper, in the passenger-side (right-hand) position on left-hand-drive vehicles. Sweeps the windscreen to clea...

Front Wiper Blade for the left-hand position on left-hand-drive vehicles, part of the windscreen wiper system. It mounts to the front wiper arm an...

Front Wheel Knuckle - Right-Hand for the front suspension and steering assembly. The wheel knuckle is the central pivot component of the front cor...

Front Wheel Knuckle - LH is a structural component in the front axle assembly. It carries the front wheel bearing and hub assembly, and provides at...

CV Boot Kit

Parking Brake Adjuster Kit for the rear parking brake (drum-in-disc) mechanism. The kit renews the adjuster components that set the clearance betw...

Handbrake Actuating Pawl Rod Actuating rod within the rear parking brake mechanism of the drum-in-disc handbrake assembly. It transmits handbrake ...

Thermostat - engine coolant thermostat for the 2.5L 6-cylinder BMW M51 diesel engine, part of the engine cooling circuit. The thermostat is fitted...

Water Pump for the engine cooling circuit — the belt-driven coolant pump assembly. Mounted at the front of the engine, the pump circulates coolant...

Parking Brake Shoe Fitting Kit for the drum-in-hat parking brake housed within the rear brake discs. The kit supplies the retaining pins and clips...

Brake Hose for the front braking hydraulic circuit. This flexible hose carries pressurised brake fluid from the rigid chassis-mounted brake line to...

Brake sensor ABS - RRSport

Brake pad wear sensor

Brake Disc - vented front brake disc, part of the front disc brake assembly. The disc is mounted to the front hub and rotates with the road wheel;...

Anti-Roll Bar Bush for the front suspension, locating the front anti-roll (stabiliser) bar to the body. The bush clamps around the bar and allows ...

Anti-Roll Bar Bush - a mounting bush in the rear suspension anti-roll (stabiliser) bar assembly. It clamps the rear anti-roll bar to the body, loc...

Rear Knuckle Bush - Upper from the rear independent suspension knuckle assembly. The bush presses into the upper bore of the rear knuckle and form...

Rear Lower Suspension Arm Bush for the front pivot of the rear lower arm, within the rear knuckle and suspension arm assembly. The bush forms the ...

Rear Anti-Roll Bar Link for the rear stabiliser (anti-roll) bar assembly. The drop link connects the end of the anti-roll bar to the rear suspensi...

Link

Track Rod End - outer ball joint in the steering linkage, connecting the track rod to the steering arm on the knuckle. The joint transfers steerin...

Intercooler Hose - Upper, Right-Hand for the charge-air (boost) circuit of the 3.6L V8 32V DOHC diesel engine. This is the upper hose on the right...

Intercooler Hose - left-hand upper hose in the charge air (intercooler) circuit of the 3.6L V8 32V DOHC turbo diesel (Lion TDV8). It carries press...

Air Filter Element - replaceable air cleaner element for the 4.4L V8 M62 petrol engine induction system. The element is carried in the air cleaner...

Viscous Fan Coupling for the 4.4L V8 DOHC petrol engine, mounted between the front drive pulley and the engine cooling fan. The coupling drives th...

Water Pump for the 3.0L M57 D30 inline-six turbo diesel engine, the belt-driven pump at the centre of the engine cooling circuit. It circulates co...

Radiator Assembly - the primary heat exchanger of the engine cooling circuit, mounted at the front of the vehicle behind the grille. Hot coolant l...

Radiator Assembly for the 4.0L and 4.6L V8 Petrol engine cooling circuit. This radiator assembly is the primary heat exchanger in the engine cooli...

Coolant Tube forming the primary coolant path between the cylinder block and the water outlet. This aluminium tube carries coolant from the engine...

Radiator to eng vent elbow hose

Water Pump is the engine-driven mechanical pump that circulates coolant through the cylinder block, cylinder heads and radiator to maintain engine ...

O-Ring seals the thermostat housing on the 2.5L six-cylinder diesel. It seats at the thermostat housing joint in the engine cooling circuit, seali...

Oxygen (Lambda) Sensor for the rear, post-catalyst position in the exhaust system. Mounted in the downpipe downstream of the catalytic converter, ...

Front Suspension Arm - left-hand upper control arm (wishbone) in the front double-wishbone suspension assembly. The upper arm connects the top of ...