Range Rover Sport L494 Parts

Crankshaft Position Sensor for V6 and V8 petrol engines. The sensor reads the crankshaft trigger wheel to report rotational position and speed to ...

Fuel Crossover Tube is the high-pressure fuel crossover pipe within the fuel injection system. It carries high-pressure fuel across the engine bet...

Thermostat and Housing assembly for the 2.0L 16V TIVCT turbocharged petrol (GTDi) engine. The thermostat regulates coolant flow to bring the engine...

Water Manifold Gasket for the engine cooling and heater circuit - it seals the water manifold tube where it leaves the cylinder block and feeds the...

Crankcase Breather Tube - a hose in the crankcase emission control (crankcase ventilation) system on petrol engines. The tube routes blow-by gases...

Pin, 6 x 36mm, from the timing gear and auxiliary drive assembly of the 5.0L AJ133 V8 petrol engine. It serves as the guide pin for the auxiliary ...

Crankshaft Front Oil Seal for the timing gear cover, sealing the crankshaft nose where it passes out through the front cover. It runs on the crank...

Oil Level Sensor Wire - wiring lead that connects the oil level sensor in the oil pan to the engine harness. Part of the oil pan and oil level indi...

Front Brake Caliper Attachment Kit supplying the pad-retaining and caliper attachment hardware that secures the brake pads in the front caliper bod...

Pulley - Fan

Blind Anchor Nut - a threaded anchor nut that provides a captive fixing point where the reverse side of the panel is inaccessible. It is used in t...

Primary Fuel Filter for the 3.0L V6 diesel engine. The primary filter sits in the front fuel supply line and removes contaminants and water from th...

Oil Sump Gasket seals the oil pan (sump) to the cylinder block on the V6 diesel engine. It maintains an oil-tight joint at the base of the engine,...

Bolt

Bolt for the exhaust system front section. This fastener secures the flanged joint between the exhaust manifold and the front pipe section, holdin...

Tyre Pressure Sensor - wheel-mounted pressure and temperature sensor for the Tyre Pressure Monitoring System (TPMS). Mounted at the valve position...

Oil Separator is the crankcase ventilation (PCV) oil separator for the 2.0L 16V turbocharged petrol engine. It sits in the crankcase breather circ...

Thermostat Housing for the 2.0L Ingenium petrol engine (AJ200P, including PHEV applications). The housing holds the coolant thermostat and forms p...

Bolt - M8 x 75mm secures the lower timing gear on the V6 diesel engine. It is a fastener within the timing gear drive assembly. Thread size M8, le...

Intercooler to Inlet Manifold Gasket from the charge air induction system of the supercharged 5.0L V8 petrol engine (AJ133). The supercharger and ...

Vacuum Hose for the 5.0L supercharged V8 petrol engine (AJ133). It routes engine vacuum between components within the vacuum circuit, supplying the...

Hose and Bracket - Heating

Rear Brake Pad Kit for vehicles built with the size 19 rear disc and caliper package, supplied as a complete rear axle set - one kit covers both re...

Thermostat for the engine cooling system on the 3.0L 24V DOHC V6 turbo diesel engine. It regulates coolant flow between the engine and radiator, s...

Thermostat & Housing is a combined coolant thermostat and housing assembly within the engine cooling system. The thermostat regulates coolant ...

Ignition Coil for the engine ignition system. It steps up battery voltage to the high voltage needed to fire the spark plug and is mounted directly...

EGR Tube connecting the exhaust manifold to the EGR valve on the 3.0L V6 turbo diesel engine. Carries hot exhaust gas from the exhaust manifold to...

Housing and Thermostat

Fuel Injection Pump Bolt secures the high-pressure fuel injection pump to its mounting on the engine. It provides the clamping load that holds the...

Heater Pipe - rigid heater manifold tube in the engine coolant circuit of the 5.0L V8 supercharged petrol engine. The pipe carries hot coolant fro...

Thermostat Housing for the engine cooling circuit. It houses the coolant thermostat and directs coolant flow, opening the path to the radiator once...

Solenoid Switch for the centre console switch pack, serving as the engine start-stop control. Mounted in the console and facia switchgear, it sign...

Radiator Hose - moulded coolant hose in the engine cooling circuit, for 5.0L AJ133 V8 petrol and 3.0L supercharged V6 petrol applications. The hos...

Steering Gear Connecting Rod is a steering linkage rod connecting the steering gear to the wheel-end steering arm. It transfers steering movement ...

Oil Pan Gasket - seals the oil pan (sump) to the cylinder block on the 4.4L V8 diesel engine. It forms the oil-tight joint between the sump and th...

EGR Tube connecting the exhaust manifold to the EGR valve on the 3.0L V6 turbo diesel engine. Carries hot exhaust gas from the exhaust manifold to...

Door Trim Panel for the front door. The trim panel finishes the inner face of the front door, covering the door structure and mechanisms and carry...

Gasket - Cylinder Head

Tailgate Latch is the closure latch of the tailgate / luggage compartment lock controls. It engages the body-mounted striker to hold the tailgate ...