624432 - Thrust Washer – Steering Relay

Sold out

- €17,30

€17,30

€17,30 - €17,30

€17,30

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Thrust Washer Fitted within the steering relay, where it controls end-float of the relay shaft against the housing.

The steering relay transfers movement from the steering box drop-arm to the drag link in the steering linkage.

Alternative Codes

624432

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What is the 624432 Thrust Washer used for?

This thrust washer fits within the steering relay, where it controls end-float of the relay shaft against the housing. The relay transfers movement from the steering box drop-arm to the drag link in the steering linkage.

How many of these thrust washers are typically needed?

Steering relay thrust washers are typically used in pairs or sets to control end-float on both sides of the shaft, so check your relay's original washer count before ordering just one.

Why would this thrust washer need replacing?

Thrust washers typically wear thin over time from repeated shaft movement, which increases play in the steering relay and can cause looseness or knocking felt through the steering. Replacing a worn washer restores the correct end-float.

What tools are needed to fit this thrust washer?

Fitting typically requires stripping down the steering relay housing to access the shaft, so this is usually a specialist job rather than a quick DIY swap. A press or suitable drifts are typically needed to reassemble the relay.