EGQ100230 - Sunroof Motor Assembly

Sold out

- €350,00

€350,00

€350,00 - €350,00

€350,00

Genuine: Original manufacturer part. This product is the original part designed and produced by the vehicle manufacturer.

Sunroof Motor Assembly – the electric drive motor for the factory sliding roof panel.

Mounted to the sunroof cassette, the motor drives the glass panel open and closed through its operating mechanism. A worn or failed motor typically leaves the roof stuck, slow, or moving erratically, and is replaced as a complete unit.

Vehicle Model Land Rover Discovery 1 1989-1998 (L318)
Land Rover Discovery 2 1998-2004 (L318)

Alternative Codes

EGQ100230

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What does the Sunroof Motor Assembly do?

The Sunroof Motor Assembly is the electric drive motor for the factory sliding roof on the Land Rover Discovery 1 (1989-1998) and Discovery 2 (1999-2004). Mounted to the sunroof cassette, it drives the glass panel open and closed, and is replaced as a complete unit.

How do I confirm this motor fits my Discovery?

This motor fits Land Rover Discovery 1 and Discovery 2 models equipped with the factory sliding roof. Not every Discovery was specified with a sunroof, so confirm yours has the powered glass panel before ordering. Twin-sunroof cars may use a motor per roof.

What are the signs the sunroof motor needs replacing?

A failing sunroof motor on the Discovery 1 or Discovery 2 typically leaves the roof stuck, slow, or moving erratically. It's supplied as a complete assembly, so a worn motor is replaced as a unit rather than stripped and repaired.

Is replacing the sunroof motor a DIY job?

Replacing the sunroof motor typically requires access to the sunroof cassette behind the headlining on the Discovery, so it's usually a workshop-level job. The mechanism normally needs aligning afterward so the panel opens, closes, and seals correctly.