EHD100140 - Sunroof Sliding Guide

Sold out

- €183,00

€183,00

€183,00 - €183,00

€183,00

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Sunroof Sliding Guide – the guide within the sliding roof assembly that locates and supports the panel as it travels.

The guide runs along its rail in the sunroof cassette, keeping the drive cable and glass panel aligned and supported as the roof opens and closes. This is the right-hand guide, with a matching guide fitted on the opposite side.

Vehicle Model Range Rover Classic up to 1994
Range Rover Classic 1994-2001 (P38)

Alternative Codes

EHD100140

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What does the Sunroof Sliding Guide do?

The Sunroof Sliding Guide locates and supports the glass panel as it travels within the sliding roof on the Range Rover Classic (up to 1994) and Range Rover P38 (1994-2001). It runs along its rail in the sunroof cassette, keeping the drive cable and panel aligned as the roof opens and closes.

Which side is this guide for?

This is the right-hand sunroof sliding guide, with a matching guide fitted on the opposite side. The guides typically wear or seize in pairs, so many owners replace both sides together when the roof starts to bind or run unevenly.

How do I confirm this fits my Range Rover?

This guide fits the Range Rover Classic (up to 1994) and Range Rover P38 (1994-2001) with the factory sliding sunroof. Confirm your vehicle has the powered glass roof before ordering, as guides differ between sunroof designs. Use your VIN to check the original roof specification.

Is the sunroof guide a DIY replacement?

Replacing the sunroof guide typically means removing the sliding roof cassette to reach the rails, so it's usually a workshop-level job. The drive cable and panel normally have to be realigned afterward so the roof travels smoothly without binding.