EHD100150 - Sunroof Guide Assembly – LH

Sold out

- €350,00

€350,00

€350,00 - €350,00

€350,00

OEM: Made by an Original Equipment Manufacturer. This part is made by an original equipment manufacturer or under their license, ensuring compatibility and quality.

Sunroof Guide Assembly – the left-hand guide within the sliding roof assembly that locates and supports the panel as it travels.

The guide runs along its rail in the sunroof cassette, keeping the drive cable and glass panel aligned and supported as the roof opens and closes. This is the left-hand assembly, with a matching guide fitted on the opposite side.

Vehicle Model Range Rover Classic up to 1994
Range Rover Classic 1994-2001 (P38)

Alternative Codes

EHD100150

Not available

This item is currently unavailable. Contact us for alternatives.

Job kits containing this part

This part is included in 0 job kit(s) below. Pick the kit that matches your vehicle and job, then add what you need.

Frequently asked questions

What does the Sunroof Guide Assembly do?

The Sunroof Guide Assembly locates and supports the glass panel as it travels within the sliding roof on the Range Rover Classic (up to 1994) and Range Rover P38 (1994-2001). It runs along its rail in the sunroof cassette, keeping the drive cable and panel aligned as the roof opens and closes.

Which side does this guide fit?

This is the left-hand sunroof guide assembly, with a matching guide on the right-hand side. The two guides typically wear together, so it's common to replace both sides at once when the roof binds or runs unevenly on a Range Rover Classic or P38.

How do I confirm this fits my Range Rover?

This left-hand guide fits the Range Rover Classic (up to 1994) and Range Rover P38 (1994-2001) with the factory sliding sunroof. Confirm your vehicle has the powered glass roof before ordering, as guides differ between sunroof designs. Use your VIN to verify the original roof specification.

Is fitting the sunroof guide a DIY job?

Fitting the sunroof guide typically requires removing the sliding roof cassette to reach the rails, so it's usually a workshop-level task. The panel and drive cable normally need realigning afterward so the roof opens and closes without binding.