Land Rover Parts

O-Ring sealing a turbocharger oil and coolant connection within the turbocharger lubrication and cooling circuit. It seals the union at the turboc...

Cylinder Head Gasket seals the cylinder head to the engine block on the 2.0L Ingenium four-cylinder diesel engine (AJ200 series). It seals the com...

Drive Shaft Coupling for the rear driveshaft, connecting the driveshaft to the driveline flange. The flexible coupling transmits drive while dampi...

Air Filter Element for the engine air intake system, seated within the air cleaner housing. The element traps dust and airborne particles from the...

Tyre Pressure Sensor (TPMS) for the direct tyre pressure monitoring system. Fitted at the wheel valve inside the tyre, it measures tyre pressure an...

Wiper Blade - RH is the right-hand front windscreen wiper blade, fitted to left-hand-drive vehicles.

Electronic Parking Brake Actuator for the rear brake caliper, part of the electronic parking brake (EPB) system. The actuator is a self-contained ...

Brake Pad Set for the rear axle, fitting the rear brake calipers. Supplied as a complete set of friction pads for the rear axle. The pads act agai...

Climate Control Humidity Sensor, an input device for the automatic climate control system. Mounted at the base of the interior rear-view mirror, i...

Rear Differential Oil Seal Kit - a set of oil seals for the rear differential and rear drive unit. The kit supplies the seals needed when resealin...

Power Transfer Unit Seal is an oil seal for the Power Transfer Unit (PTU) on transverse all-wheel-drive models. The PTU takes drive from the trans...

Torque Converter Oil Seal seals the front of the ZF 9HP nine-speed automatic transmission where the torque converter hub enters the pump housing. I...

Output Shaft Oil Seal seals the transmission output shaft where it exits the case on the ZF 9HP48 / 9HP50 nine-speed automatic gearbox. It runs aga...

Clutch Master Cylinder - the hydraulic actuator at the head of the clutch circuit. Mounted on the pedal box, it converts clutch-pedal effort into h...

Radiator is the engine coolant radiator for 2.2L diesel applications. It dissipates heat from the engine coolant as it flows through the core, mai...

Trim Clip - push-fit fastener securing exterior body mouldings, front and rear bumper trim and the radiator grille to the body panels. Renews an o...

Plastic Rivet is a push-fit fastener that secures front engine-compartment insulation panels to the body. It locates into a pre-formed panel hole t...

Exhaust Manifold Gasket seals the exhaust manifold to the cylinder head on the 2.0L 16V petrol engine. Fitted between the head's exhaust ports and...

Crankshaft Damper Washer for the 2.0L 16-valve turbocharged petrol engine, fitted in the crankshaft damper assembly at the front of the timing gear...

Transmission Oil, SAE 75W, meeting specification BOT 352, supplied in a 1 L bottle. For the 6-speed manual transmission (M66) and, on hybrid appli...

Front Lower Engine Mounting is the lower insulator supporting the engine at the front of the mounting system. It locates the engine to the subfram...

Upper Knuckle Bolt is a hex-head bolt that retains the upper knuckle joint within the hub and knuckle assembly. It clamps the upper knuckle to the...

EGR Gasket for the 2.2L diesel engine, part of the exhaust gas recirculation (EGR) system. Seals a joint in the EGR circuit, maintaining a gas-tig...

Flanged Nut with an integral flange that spreads the clamping load and helps resist loosening, removing the need for a separate washer. Used to se...

Exhaust Manifold Nut is a hexagon nut used on the exhaust manifold fixings of the 2.2L 16V common-rail diesel engine (DW12). Manifold fasteners ru...

Starter Motor for the 2.2L Td4 diesel engine (DW12), part of the engine starting system. It cranks the engine through a pinion that engages the ri...

Head Gasket - 3.0 TDV6 - Grade 3

Front spring pad for the front suspension strut and coil spring assembly. The pad is an elastomer insulator that seats between the end of the coil...

Oil Cooler Return Connector is a connector fitting in the engine oil cooler circuit of the 2.2L diesel engine (DW12). It joins the oil cooler retu...

Oil Filter Housing Cover for the oil cooler and filter housing on the 2.2L DW12 turbo-diesel engine. The cover closes the oil filter housing, reta...

Oil Seal - M66 Gearbox Driveshaft is the 67mm driveshaft oil seal for the M66 six-speed manual transmission. It seals the driveshaft output where ...

Coolant Hose Assembly - heater outlet to thermostat housing hose in the engine cooling circuit. Returns coolant from the heater matrix outlet to t...

Camshaft Oil Seal (Front) for the 2.2L DW12 Td4 diesel engine, fitted where the camshaft exits the front of the cylinder head. The seal runs on th...

Service Kit - Dis SP & Evo - 2.2 Die

Piston - 0.50 mm Oversize for the 2.0-litre Ingenium (AJ200D / 204DTD) diesel engine. An engine-rebuild piston machined 0.50 mm over the standard ...

Haldex Coupling Fluid - Ravenol AWD-H, in a 300 ml bottle. Used to service the Haldex all-wheel-drive coupling on the rear axle. Meets Land Rover ...

Hood Latch for the bonnet closing mechanism. The latch is body-mounted and engages the bonnet striker to hold the bonnet shut, releasing when the ...

Flange Bolt Hex-head flange bolt, M8 x 1.25 x 80mm. General-purpose fastener used in chassis frame and component mountings.

Windscreen Washer Pump Grommet seals the washer pump into the windscreen washer fluid reservoir. This rubber grommet fits into the reservoir body ...

Relay Black 2A 4 Pin

torx screw and washer, M6x18mm OEM

Wheel Bearing Circlip - 51 mm retaining ring for the wheel hub bearing. Seats in the groove of the knuckle bore and locates the hub bearing axiall...

Coolant Level Warning Sensor for the engine cooling system. This sensor is fitted to the coolant expansion tank and monitors coolant level via an ...