Land Rover Parts

Rear Brake Disc - solid (non-vented), cross-drilled and grooved - the rotating friction element of the rear disc brake assembly. The rear axle car...

Air Suspension Compressor Mounting - rubber isolator supporting the electronic air suspension compressor at its rear mounting point. The compresso...

Retainer

Body Rivet - a mechanical fastener used within the body and panel assembly to join thin sheet metal, trim and stowage fittings. Nominal size 3/16"...

Hexagonal Screw - sump pan retaining screw for the ZF four-speed automatic transmission. The screw passes through one of the pressed retaining pla...

Straight Fixing Plate - pressed retaining plate for the automatic transmission sump pan, straight (side) position. The sump pan on the ZF four-spe...

Corner Fixing Plate - pressed retaining plate for the automatic transmission sump pan, corner position. The sump pan on the ZF four-speed automati...

Blade Fuse rated at 30 A. Standard blade-type fuse for the vehicle fusebox. It protects a single circuit by melting its internal element when curr...

Blade Fuse rated at 3 A. Standard blade-type fuse for the vehicle fusebox. It protects a single circuit by melting its internal element when curre...

Fully synthetic engine oil, SAE 5W-40 - 5 litre container. Engine lubrication system. A 5W-40 multigrade: the 5W winter rating gives cold-start fl...

Fully synthetic engine oil, SAE 5W-40 - 1 litre container. Engine lubrication system. A 5W-40 multigrade: the 5W winter rating gives cold-start fl...

Damper Mounting Bush - Lower - isolating bush for the lower shock absorber mounting. The bush sits between the damper mounting and its bracket, is...

Rear Air Spring for vehicles fitted with Electronic Air Suspension (EAS). The air spring is the rubber bellows that takes the place of a rear road ...

Hex Nut, M24 x 1.5mm securing the constant-velocity (CV) joint stub shaft to the wheel hub within the driveline. The nut retains the CV joint and ...

Air Spring for the front of the electronic air suspension system. The air spring takes the place of a conventional coil spring, using a flexible ru...

Panhard Rod Bush from the front suspension's lateral location linkage. The Panhard rod controls sideways movement of the axle relative to the body...

Panhard Rod Bush from the front suspension's lateral location linkage. The Panhard rod controls sideways movement of the axle relative to the body...

Lower Steering Shaft is the intermediate shaft assembly between the base of the steering column and the steering box. It transmits steering input ...

Drag Link Assembly forms part of the steering linkage, connecting the steering box drop arm to the steering arm at the road wheel. It transmits the...

Drag Link Assembly for the steering linkage, right-hand drive applications. The drag link transmits movement from the steering box drop arm to the...

Track Rod End is a ball-jointed link in the steering linkage, connecting the track rod to the steering arm and articulating as the steering and sus...

Track Rod - RHD

Side Repeater Lens is the lens cover for the side repeater indicator lamp. It fits over the repeater lamp bulb to seal the unit and colour the emi...

Anti-lock braking system relay - black plug-in relay fitted in the fuse and relay box at relay position RL17. It switches the power supply into th...

Alternator Drive Belt - 2322mm polyvee (multi-rib) belt from the accessory drive of the V8 EFI petrol engine. The belt is driven off the crankshaf...

Idler Pulley - a smooth-faced guide pulley in the V8 auxiliary (serpentine) drive belt system. Mounted on a fixed pivot, it routes the accessory d...

Coolant Outlet Elbow for the V8 petrol engine, part of the coolant outlet (water rail) at the front of the engine. The elbow takes coolant leaving...

Hose - Heater Water

Expansion Tank Hose - Upper for the Range Rover P38 cooling system. This hose connects the upper port of the coolant expansion tank to the main co...

Coolant Expansion Tank Cap rated at 1.4 bar, fitted to the expansion (header) tank of the engine cooling system. The cap seals the expansion tank ...

Radiator Assembly - the main coolant-to-air heat exchanger of the engine cooling system, carried in the front panel ahead of the engine. Coolant d...

Radiator Assembly - the primary heat exchanger of the engine cooling circuit, mounted at the front of the vehicle behind the grille. Hot coolant l...

Radiator Assembly for the 4.0L and 4.6L V8 Petrol engine cooling circuit. This radiator assembly is the primary heat exchanger in the engine cooli...

Battery - Wet Non-Spillable - sealed lead-acid starting and deep-cycle battery with dual terminals. Rated at 68 Ah with 1500 cranking amps. The pl...

Oil Cooler Hose - oil cooler to filter housing, part of the engine oil cooling circuit. This flexible line carries pressurised engine oil between ...

Engine Oil Cooler Assembly - heat exchanger in the engine oil cooling circuit, for diesel engines with manual transmission. Engine oil is fed from...

Hex Nut - M10, air spring and damper mountings. Plain M10 hexagon nut used on the air spring and damper mounting fasteners. Supplied individually....

Clutch Hose for the 300 Tdi 2.5L turbo diesel, forming the flexible section of the clutch hydraulic actuation circuit. The hose links the rigid pi...

Front Brake Disc (Vented) - the rotor in the front disc brake assembly. The brake caliper clamps its pads against the faces of this disc to slow t...

Front Brake Disc - vented rotor for the front braking assembly. The disc mounts to the front wheel hub and provides the friction surface the brake...

Front Brake Disc (Vented) - the rotor in the front disc brake assembly. The brake caliper clamps its pads against the faces of this disc to slow t...

Knock Sensor for V8 EFi petrol engines under Bosch engine management, mounted on the cylinder block as part of the ignition control circuit. The s...

Fuel Pipe Union Nut for the fuel delivery line. This female threaded nut draws a fuel pipe up to its mating union, clamping the pipe's flared or c...

HT ignition lead for the No.7 cylinder position, part of the high-tension lead set in the ignition system of the V8 EFI petrol engine. Carries the...

HT ignition lead for the No.2 cylinder position, part of the high-tension lead set in the ignition system of the V8 EFI petrol engine. Carries the...

HT Ignition Lead - V8 - No.8 Cylinder - high-tension ignition lead from the ignition coil and HT lead assembly, carrying the secondary ignition out...