Land Rover Parts

Bracket Fr RR ARB Strap

Air Intake Hose from the air cleaner assembly of the 2.5 Turbo Diesel engine. It ducts filtered air from the air cleaner housing to the turbocharg...

Accelerator Cable for the 2.25L diesel engine in left-hand drive Defender 110. This cable connects the accelerator pedal to the throttle control l...

Roof Gasket seals the joint between the roof panel and the body structure on the Discovery 1. The gasket runs around the roof panel perimeter, pre...

Seat Belt Stowage Clip from the rear seat belt assembly. It retains the seat belt webbing in a stowed position when the belt is not in use, holdin...

Rear Window Regulator - Right Hand - the mechanism that raises and lowers the rear side door glass on the right-hand side. It mounts inside the re...

Transmission Oil Cooler Hose - Diesel ZF Automatic is a hydraulic hose forming part of the automatic transmission cooling circuit on the Range Rove...

Seat Belt Assembly - three-point inertia reel front seat belt for the right-hand front seat, part of the occupant restraint system. The inertia re...

Fitment: All V8 EFi petrol models from (VIN) XA410482 on

Winch Remote Handset & Receiver is a wireless remote control set used to operate an electric recovery winch from a distance. It is supplied as...

Receiver Dryer is a component of the air-conditioning refrigerant circuit. Installed in the high-pressure liquid line between the condenser and th...

Tap Set for cutting internal left-hand (reverse) threads, supplied as a six-piece set covering a range of fine-pitch sizes. A tap cuts a threaded ...

Intermediate Shaft

Bump Stop Kit for the suspension, supplied as a set of four standard-height bump stops. The bump stop limits axle-to-chassis travel at full suspen...

Battery Condition Gauge for the instrument panel. A 52mm panel-mount gauge that displays battery voltage, providing a direct indication of chargin...

Accelerator Cable for the VM Diesel engine, left-hand-drive (LHD) configuration. Connects the accelerator pedal to the injection pump as part of th...

Rear Door Protection Plate mounts on the exterior of the rear door to shield the panel from stone chips, scuffs and impact damage during loading an...

Baulk Ring for the LT77 5-speed manual gearbox synchromesh assembly. The baulk ring is the friction cone element of the synchromesh unit. It conta...

Turbo Hose is the charge air transfer hose connecting the intercooler outlet to the inlet manifold on the Defender 2.5L Turbo Diesel engine. Follo...

Exhaust Manifold - RH End Section for the 300TDi 2.5L inline 4-cylinder turbo diesel engine. Forms the right-hand section of the two-piece cast ir...

LED Daytime Running Lights - a pair of Ring LED running lamps for the DA8600 front bumper. Each lamp uses 5 x 1.5W LEDs and measures 57 mm (H) x 1...

Mirror Ring Casing - RH Outer is the outer trim ring that surrounds the mirror glass carrier on the right-hand exterior door mirror assembly of the...

Mirror - Manual is a manually-adjusted exterior door mirror. It mounts to the door and is adjusted by hand, without electric operation.

Body Aperture Harness Grommet for the wiring harness routing assembly. Rubber grommet installed in a body panel aperture to seal and protect wirin...

Rear Door Wiper Arm for the tailgate wiper system. Mounts to the rear wiper spindle on the tailgate and carries the wiper blade across the rear wi...

Side Moulding is an exterior body trim strip for the 2-door body side. It runs along the side body panel to protect the paintwork from stone chips...

Piston for the 2.25L 4-cylinder petrol engine, forming the reciprocating member within the cylinder bore that transmits combustion pressure through...

Exhaust Silencer for the Discovery 1 exhaust system. This is the rear silencer for the non-catalyst exhaust configuration, fitted to vehicles buil...

Rear corner wing repair panel for the rear body corner, forming the outer skin where the rear quarter panel wraps round to the rear end panel behin...

CV Joint Assembly is the outer constant velocity joint in the front axle driveshaft assembly, connecting the outer end of the driveshaft to the fro...

Gearchange Housing for the LT77 5-speed manual gearbox. Mounted on top of the gearbox, it carries the gear selector mechanism and locates the gear...

5th Gear - LT77 is the mainshaft-mounted overdrive gear for the LT77 5-speed manual gearbox, located at the rear of the transmission in the 5th-gea...

Flywheel - 5-Bearing is the rotating mass mounted to the rear flange of the crankshaft in the 5-main-bearing variant of the 2.25L and 2.5L 4-cylind...

Transmission Oil Cooler for the transmission cooling circuit on V8 Petrol applications. The cooler regulates automatic or manual transmission flui...

Driveshaft Oilpump

Window Regulator for the front door, right-hand side, manual winder type (not electric). This is the mechanism that raises and lowers the front do...

Thermostat Housing Gasket in the engine cooling system. This 37 mm gasket seals the joint between the thermostat housing and the engine on AJ-V8 4...

Front outer wing RH SIII plastic

Piston Ring Set for one piston in the engine's piston and cylinder assembly. The rings seat in the piston ring grooves, sealing combustion pressure...

Air Spring - Rear - pneumatic suspension bellows unit for the rear axle of the Range Rover Classic Electronic Air Suspension (EAS) system. The air...