Land Rover Parts

Mirror Glass is the replaceable left-hand glass element for the exterior door mirror. The glass seats into the mirror housing on its backing plate...

Battery Carrier - LH is the left-hand battery mounting panel, the pressed-steel tray that supports and locates the battery within the engine bay. ...

Door Handle – Front – LH The exterior pull handle for the left-hand front door, part of the outer door locking assembly. It mounts to the outer do...

Cover fitted to enclose and protect a housing or assembly, retaining lubricant and keeping dirt and debris out of the components it encloses.

Shim for setting up the pinion in the Salisbury axle differential, 0.005 in thick. Used during differential assembly to set the pinion height and ...

Bolt with a 5/16" UNC thread, 3.82" long. A threaded fastener used to secure mating components within the vehicle assembly.

Shock Absorber Bush in rubber, fitted at the shock absorber mounting eye within the suspension damping assembly. The bush isolates the damper from...

Oil Seal for the front axle swivel pin housing. It seals against the swivel ball at the outer end of the front axle, retaining the lubricant withi...

Speedometer Cable for the instrument drive system, right-hand-drive configuration. This cable transmits rotational drive from the transfer box spe...

Camshaft Bearing - a needle roller bearing that carries a camshaft journal within the cylinder block. The bearing locates the camshaft radially in...

Butterfly Spindle Nut for the carburettor. The nut secures the throttle butterfly disc to its spindle inside the carburettor body, retaining the d...

Turbocharger Oil Drain Pipe Gasket seals the joint where the oil drain pipe returns oil from the turbocharger back to the engine. It fits between ...

Inner Column + Main Nut

Differential Casing Assembly for the Rover-type differential. This is the differential carrier casing that houses the differential gear set and ca...

Thermostat for the engine cooling circuit of the 2.6L six-cylinder petrol engine, with a 74°C opening temperature. It regulates coolant flow betwe...

Gasket A sealing gasket fitted between two mating components to seal the joint against leakage of fluid or gas and to take up minor irregularities ...

Stud secures the coolant pump to the engine front cover. Part of the coolant pump and front cover assembly on the 2.5L 200 TDi diesel engine, it p...

Front Differential is a complete front axle differential assembly that transmits drive from the front propshaft to the front halfshafts while allow...

Front Axle Differential Casing for the front drive axle. This casting forms the central housing of the front axle. It carries the differential cro...

Front Winch Bumper is a steel front bumper that replaces the standard front bumper to carry a recovery winch. It incorporates integral recovery ey...

Oil Seal seals the driving pinion of the rear differential. Fitted at the pinion nose where the propshaft drive flange enters the differential hou...

Special Nut used in the pedal box and brake pedal bracket assembly. A dedicated threaded fastener that secures the pedal mounting within the pedal...

Tab Washer - Primary Pinion is a locking washer in the manual gearbox primary pinion assembly. Fitted beneath the primary pinion retaining nut, it...

Outer Finisher - an external trim finisher fitted to the bodyside, used on the rear cab body panel and around the sliding side windows of the hard ...

Rear Subframe Angle Bracket for the rear chassis and subframe assembly. The angled bracket provides a mounting and reinforcement point at the rear...