Land Rover Parts

Mass Air Flow Sensor for the air intake system of the M47 Td4 2.0L four-cylinder turbo diesel. The sensor sits in the intake tract downstream of t...

Housing Gasket

Pump - Water Hepu

Absorber Shock - Discovery 4

Transmission Oil Cooler Pipe Assembly, part of the automatic transmission fluid cooling circuit. It routes transmission fluid between the ZF 6HP28...

Front Floor Panel is a footwell floor repair section for the body's front floor assembly. It replaces the corroded or damaged front floor panel on...

Exhaust Clamp for the Puma diesel exhaust system, on installations fitted with a diesel particulate filter (DPF). The clamp joins two sections of ...

Front Bumper - complete front bumper assembly supplied with the integrated radiator grille section. The bumper mounts across the front of the body...

Flanged Nut for use in Land Rover assembly applications. The integrated flange acts as a built-in load-spreading face, distributing clamping force ...

Tailgate Lock Plate - Branded Galvanised is a galvanised striker plate for the cable-retained tailgate. It provides the anchor point for the tailg...

Adjusting Screw for the Td5 2.5L five-cylinder turbo diesel engine rocker assembly. Sets the clearance at the rocker where it acts on the valve an...

Floor Mat - Rear is a moulded rubber floor mat for the rear of the vehicle. It protects the rear floor, providing a hard-wearing, washable surface.

Thermostat Assembly for the 2.4L Duratorq TDCi diesel, mounted in the oil cooler and filter housing. It regulates coolant flow to bring the engine...

Inlet Manifold Gasket for the 1.8L K-Series petrol engine, fitted in the induction system between the inlet manifold and the cylinder head. It sea...

Extended Bump Stop - a direct replacement for the standard axle bump stop, mounting to the chassis bracket through two bolt holes. Taller than the...

Mudshield Bracket supports the rear brake disc mudshield (splash/backing shield) at the rear axle. The bracket locates the shield behind the brake...

Transfer Box Clevis Pin for the LT230 transfer box gear change linkage. This clevis pin connects the high/low gear change lever to the transfer bo...

Gearbox Retainer - LT77

Carburettor meters the air and fuel supplied to the 2.5L petrol engine, mounting on the inlet manifold at the head of the fuel system. It is a twi...

Cold Start Injection Hose - part of the fuel injection system, within the injector and pipe assembly. It feeds fuel to the cold start injector, whi...

Bonnet Latch Assembly for the bonnet (hood) closure, the primary latch that secures the bonnet to the front body panel. It engages the striker on ...

Power Steering Pump Pulley mounts on the power steering pump shaft within the steering hydraulic circuit. Driven by the auxiliary drive belt, it t...

Breather cap for the rocker cover, part of the engine crankcase ventilation system. Fits the 2.25L four-cylinder petrol and diesel engines.

Coolant Pipe is a rigid coolant transfer pipe in the cooling circuit of the 3.5L V8 (twin-carburettor) petrol engine. It carries coolant between t...

Steering Column Top Shim used in the steering column assembly of the Range Rover Classic. This shim is fitted at the top of the steering column to...

Layshaft Shim for the LT95 4-speed gearbox. The shim sets the endfloat of the layshaft (countershaft) within the LT95 gearbox casing, fixing its a...

Tensioner Pulley Bearing for the auxiliary drive belt system on air-conditioned vehicles. It is the bearing carried within the idler/tensioner pul...

Halfshaft for the rear axle, left-hand side. The halfshaft is the rotating drive member that transmits torque from the differential to the rear whe...