Land Rover Parts

Coolant Flow Control Valve - regulates coolant flow within the thermostat and housing assembly. It controls circulation through the cooling circui...

Cylinder Head Gasket for the right-hand cylinder bank of the 3.0L supercharged V6 petrol engine (DOHC GDI). It seals the cylinder head to the engin...

Drive Chain Tensioner

Cylinder Head Gasket for the 2.0L I4 (AJ200 / AJ20D4) diesel engine. It seals the joint between the cylinder head and the engine block, sealing com...

Cylinder Head Gasket for the left-hand cylinder bank of the 3.0L supercharged V6 petrol engine (DOHC GDI). It seals the cylinder head to the engine...

Front Wiper Blade - Driver's Side is the driver's side blade of the front windscreen wiper system in left-hand drive configuration. It is the long...

Brake Actuator - electric parking brake (EPB) actuator, part of the electronic parking brake assembly. The motor-driven actuator applies and relea...

Water Valve - coolant control valve in the auxiliary fuel-fired pre-heater circuit. The valve opens and closes the heater loop against the main en...

Throttle Body and Motor for the engine intake assembly on the 3.0L V6 Diesel Gen 2 engine. This assembly houses the throttle valve and its integra...

Bolt securing the fuel injector and high-pressure fuel pipe assembly on the engine fuel system. It clamps the injector and high-pressure pipe unio...

Radiator is the primary heat exchanger of the Engine Cooling System, transferring heat from the engine coolant to the air drawn through the front c...

Camshaft Cover Gasket sealing the camshaft cover to the cylinder head. It seals the joint between the camshaft (cylinder head) cover and the cylin...

Timing Chain Tensioner, part of the timing chain drive within the timing cover. It applies controlled load to the timing chain guide to keep the ch...

Brake Pad Set - Rear - friction pad axle set for the rear disc brake assembly. The pads locate in the rear caliper carriers and clamp against the ...

MacPherson Strut

Front Wheel Knuckle - Right-Hand for the front suspension and steering assembly. The wheel knuckle is the central pivot component of the front cor...

Brake Disc - front vented brake disc forming part of the front braking assembly. The disc provides the friction surface against which the front br...

Brake Wear Sensor Wire for the rear brake assembly. The sensor wire is routed to the rear brake pad and completes an electrical circuit that signa...

Front Lower Suspension Arm, left-hand side, supplied as a complete arm with its mounting bushes and integral lower ball joint. The arm links the f...

Oil Pump, the pump at the heart of the engine lubrication system. Driven by the engine, it draws oil from the sump and delivers it under pressure ...

Coolant outlet tube forming the water outlet connection at the cylinder head, in the engine cooling circuit of the 2.0L I4 AJ200 Ingenium petrol en...

Coolant Vent Hose - connects the engine vent elbow to the radiator, within the vent (bleed) circuit of the engine cooling system. The hose carries...

Wheelarch Eyebrow is the front wheelarch eyebrow moulding, part of the front wheelarch trim assembly. It mounts to the upper section of the front ...

Magnetic Oil Drain Plug - M14 x 21 sump drain plug in the engine lubrication system. The plug seals the drain aperture in the oil sump and is remo...

Spark Plug - ignition spark plug for Ingenium petrol engines (AJ20 / AJ22 series, including PHEV applications). The plug screws into the cylinder ...

Arm - Suspension - Front - LH - Lower

Cabin Pollen Filter for the front heating, ventilation and air conditioning intake housing. The element sits in the HVAC filter tray upstream of t...

Gasket

Wiper Blade forms part of the windscreen wiper system, clearing rain and debris from the windscreen glass as it is swept across by the wiper arm.

Brake Disc for the front braking system, 350 mm diameter. It provides the friction surface for the front brake pads, converting the vehicle's momen...

Cylinder Head Bolt for the 2.0L Ingenium diesel engine (AJ200 / AJ20D4), securing the cylinder head to the engine block. Supplied as a single bolt...

Camshaft Cover Gasket - the sealing gasket between the camshaft (cylinder head) cover and the cylinder head. It seals the cam cover to the head to...

Fuel Pump - high-pressure, engine-mounted fuel injection pump within the direct-injection fuel system on petrol engines. Driven off the engine, it...

Brake Pad Kit - Front - front axle set of disc brake pads for the 19-inch front brake disc and caliper installation. The pads are clamped against ...

Camshaft Cover for the cylinder head. Encloses the camshafts and valvetrain and seals the top of the cylinder head. For the 3.0L supercharged V6 p...

Water Outlet Connection - coolant outlet component in the engine cooling circuit of the 3.0L DOHC GDI supercharged V6 petrol engine. It forms the ...

Engine coolant temperature sensor for the Bosch engine management system on the 4.0L and 4.6L EFi Rover V8 petrol engine. The sensor threads into ...

Heated exhaust gas oxygen (HEGO) sensor, front (pre-catalyst) position, for the 4.4L V8 petrol engine (M62 B44). The sensor sits in the exhaust up...

Alternator for the 3.6L TDV8 turbo diesel, part of the engine charging system on the auxiliary belt drive. Driven by the accessory drive belt from...

Suspension Arm - upper front control arm for the left-hand side, 247 mm between pivot centres. The arm ties the top of the front wheel knuckle to t...

Front lower suspension arm (wishbone), right-hand side, from the front strut suspension assembly. The arm locates the base of the wheel knuckle ag...