Land Rover Parts

Inlet Manifold Joint Washer seals the inlet manifold to the cylinder head. It maintains an airtight joint between the manifold flange and the head...

Clutch Master Cylinder Reservoir Cap for the clutch hydraulic actuation circuit. Seals the fluid reservoir at the clutch master cylinder, retainin...

Centre Silencer Replacement Pipe for the exhaust system, fitting in place of the intermediate (centre) silencer box. The pipe provides a straight-...

Brake Cleaner & Degreaser - an acetone-free aerosol solvent cleaner for brake components and general parts cleaning. It removes dirt, grease, ...

Heater Outlet Hose is the coolant return hose from the heater matrix in the cabin heating circuit. It carries coolant from the outlet side of the ...

PDWA Valve

Split Pin used on a front-axle assembly to lock a castellated nut. The pin passes through the drilled fastener and the slots of the nut, and its le...

Power Steering Pump for the 2.5L five-cylinder turbo diesel, supplied as a complete pump assembly. Belt-driven from the engine, the pump draws flu...

Grommet

Stud - M10 x 25mm, a threaded fastening stud used across a range of Land Rover assemblies. The stud provides a fixed threaded mounting point, allo...

Wheel Centre Cap with a pewter finish, fitting the centre bore of the alloy road wheel. It conceals the hub and the wheel fixings at the centre of ...

Flame Trap fits into the crankcase ventilation circuit of the V8 twin-carburettor petrol engine, between the crankcase breather and the carburettor...

Fir Tree Fastener push-in fixing in light grey, used to retain headlining, roof trim and similar interior and exterior trim panels. The tapered fi...

Oil Pump Bolt for the Td5 2.5L 5-cylinder turbo diesel engine, securing the oil pump to its mounting on the engine. It clamps the pump body agains...

Blanking Plug closes off an unused 8mm (5/16 inch) aperture in a body panel or chassis section. It belongs to the body grommets and panel-sealing g...

Starter Motor for the engine starting circuit. When energised, the starter drives its pinion into mesh with the flywheel ring gear and cranks the ...

Steering Drop Arm Puller - a specialist tool for drawing the drop arm off the splined output shaft of the steering box. The drop arm is a tight ta...

Seat Back for the outer front seat, in the deluxe pattern and finished in black. This is the upholstered backrest (squab) the occupant leans agains...

Light Guard Set - Rear Hinged rear lamp guard set that protects the rear lamp lenses from stone strike and low-speed impact during off-road use. T...

Rear Fog Lamp with LED illumination, forming part of the rear lighting assembly, providing a high-intensity red rear light for use in poor visibili...

Fuel Return Check Valve is a non-return valve fitted in the fuel return circuit of the Td5 fuel system. It permits fuel flow in one direction only...

Parabolic Spring Kit - 2-Leaf Front Pair is a front leaf-spring suspension set that replaces the original semi-elliptic multi-leaf front springs. ...

Front Lamp Guards – a hinged protective guard set for the front exterior lamps. The guards mount over the front headlamps to shield the lenses fro...

Brake Pipe for the rear left-hand side of the hydraulic braking circuit. This rigid metal pipe carries pressurised brake fluid along the chassis to...

Rear Upper Suspension Arm for the left-hand side, forming part of the rear independent suspension linkage. It connects the rear hub carrier to the...

Lucar Connector - a fully insulated two-way in-line electrical connector for joining wiring within the loom. Of the Lucar (blade) terminal type, i...

Bulkhead Outrigger is a structural bracket that supports the right-hand side of the bulkhead and ties it to the chassis frame, carrying the load wh...

Water Pump for the Rover V8 petrol engine, of the viscous-drive type. It mounts to the front of the engine and forms part of the engine cooling cir...

Windscreen Bracket is the left-hand mounting bracket that secures the windscreen frame to the body at its lower fixing point, for the fixed (non-fo...

Windscreen Bracket is the right-hand mounting bracket that secures the windscreen frame to the body at its lower fixing point, for the fixed (non-f...

Rear Indicator Lamp for the exterior lighting system, fitted within the rear lamp cluster. It provides the rear directional turn-signal indication...

Front direction indicator lamp assembly used in the exterior lighting system, mounted on the front wing to provide visual signalling for directiona...

Mirror Arm for a door-mounted exterior mirror, within the exterior mirror assembly. This is an extended arm of the Wolf (XD) pattern, holding the ...

Bumper Lamp Assembly, left-hand side, part of the rear bumper lighting cluster. A combined lamp unit with a red lens section serving the stop and ...

Lamp assembly indicator front RH

Fuel Pump Diaphragm for the mechanical fuel pump on petrol engines, with a T-bar notched shaft for the later type of pump. This is the diaphragm o...

Wing Top Protectors are 3mm chequer plate aluminium panels that fit over the top surface of the front wings. Fitted over the wing top sheet metal,...

Lock Nut is a captive plastic fastener (commonly known as a Lokut nut) that receives a No. 10 self-tapping screw. The body pushes into a square pa...

Flange Bolt, M12 - a hexagon-head bolt with an integral flange beneath the head. The flange spreads the clamping load over a wider bearing area an...

Air intake duct hose Def 2.5DT & 200TDi air cleaner to turbocharger

Wiper Blade - Passenger Side - J-Hook

Handbrake Spring Kit for the transmission brake – the drum-type parking brake mounted at the transfer box output. The kit comprises the shoe reten...

Driving Member (axle drive flange) for the front and rear hub assemblies. It bolts to the outer face of the hub and engages the splined end of the ...

Drive Belt Idler Pulley for the auxiliary (accessory) belt drive of the Td5 2.5L 5-cylinder turbo diesel engine. The pulley mounts above the water...

Contact Set for the ignition distributor of the 3.5L V8 petrol engine. The contact breaker points open and close the primary circuit to the ignitio...

LED Light Upgrade Kit (coloured lens type) - a complete set of WIPAC 73mm LED lamps replacing the original incandescent front and rear exterior lam...

Steering Box Cover - LHD - inner wing mudshield for the steering box. This pressed cover fits over the steering box on the inner wing panel, shiel...

Anti-Roll Bar Bolt Protector for the rear suspension. It fits over the rear anti-roll bar mounting strap and its retaining bolt, shielding the fixi...