Land Rover Parts

Side Grille for the right-hand front wing. Exterior trim grille fitted to the side of the front wing, providing a styling and venting feature. Mou...

Oil Seal for the transfer case input shaft. Seals the input shaft where it enters the transfer case, retaining lubricant and excluding contaminant...

Transfer Case Shift Motor - the electric actuator that changes the transfer box between high and low range on the electronically controlled two-spe...

Drive Shaft for the front axle assembly, left-hand side. Transmits drive from the front differential output to the left-hand front wheel hub, acco...

Pipe Union joins two pipe ends to form a sealed, threaded connection in a fluid line. Machined from brass with a female 5/8" x 18 UNF thread, it d...

Seat Cushion Cover - Base in Techno-pattern velour fabric, for the squab section of the front seat on Defender 90, 110, and 130 models. The Techno...

Snorkel Kit is a raised air intake that relocates the engine air intake from its standard under-bonnet position up to roof height, supplying cooler...

Steel Snorkel Kit (raised air intake) from the Mantec range, forming part of the engine air intake system. Relocates the air intake from the stand...

Lightbar , roof satin black powder coated tubular steel Discovery 1 &amp: 2

Loadspace Liner lines the rear loadspace to protect the load floor against scratching, scuffing and spills. Shaped to fit the loadspace, it shield...

Spare Wheel Cover is a rigid cover that fits over an externally mounted spare wheel. Moulded in hard plastic with a gloss black finish, it shields...

Centre Console Switch Pack moulding in black, forming part of the centre console trim. This panel mounts in the centre console and provides the ap...

Rear Half Axle Shaft - RH is the right-hand outer stub shaft in the rear axle assembly. This shaft transmits drive from the rear differential to t...

Thrust Washer - mainshaft thrust washer for the R380 five-speed manual gearbox. Located at the mainshaft 5th/reverse gears, it controls end-float ...

Gear Lever Gaiter Assembly - sealing gaiter for the manual gearbox gear lever. Fits around the base of the gear lever to seal the transmission tun...

Rear Differential Assembly - the complete crown wheel and pinion assembly in its carrier, bolting into the rear axle casing. The unit takes drive ...

Oil Feed Ring - mainshaft oil feed ring for the R380 five-speed manual gearbox. Located on the gearbox mainshaft, it channels lubricating oil to t...

Rear Flange is the rear output drive flange of the LT230 transfer box. It mounts on the transfer box rear output shaft and forms the bolted coupli...

Gear Change Selector Cable forms part of the manual gearchange linkage, connecting the gear lever to the gearbox selector mechanism. When the driv...

Clutch Driven Plate is the friction disc of the Td5 clutch. Splined to the gearbox input shaft, it is clamped between the flywheel and the pressur...

Clutch Cover is the pressure plate assembly for the Td5 clutch. Bolted to the flywheel, its diaphragm spring clamps the driven plate against the f...

Drive Plate (flexplate) couples the V8 petrol engine crankshaft to the automatic transmission torque converter. The drive plate bolts to the rear ...

Propshaft - Rear

Rear propshaft 130"" from 2A637980